Messages in this thread | | | Date | Wed, 8 May 2013 18:08:39 +0200 | From | Fabio Baltieri <> | Subject | Re: [PATCH 6/6] ASoC: ux500: Use the first two AD slots for capture |
| |
On Wed, May 08, 2013 at 11:56:54AM +0100, Mark Brown wrote: > On Wed, May 08, 2013 at 09:14:21AM +0200, Fabio Baltieri wrote: > > Set AD_OUT1 and AD_OUT2, corresponding to LINL and LINR pins, as the > > default input slots for the capture interfaces. > > If these are routing specific analogue inputs to specific timeslots then > this is routing that should be being exposed to DAPM as muxes, not hard > coded in the middle of TDM slot configuration (which is both obscure and > not what the TDM API is there for). The TDM API should be purely about > placing the timeslots for the audio interface on the bus.
Ok, it makes sense. Again, this patch was wrote as a fix to the existing codebase to make the driver usable with the actual board available to the community (the snowball).
Fabio
-- Fabio Baltieri
| |