lkml.org 
[lkml]   [2019]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v2 0/3] i2c-mux-gpio: Split plat- and dt-specific code up
Date
The main idea of this patchset was to add the full dt GPIOs specifier
support in i2c-mux-gpio driver. In particular we needed to have the
full GPIOs specifier being handled including the flags like GPIO_ACTIVE_HIGH,
GPIO_ACTIVE_LOW, GPIO_PUSH_PULL, GPIO_OPEN_DRAIN or GPIO_OPEN_SOURCE.
Due to using a legacy GPIO interface the former driver implementation
didn't provide this ability.

On the way of adding the full dt-GPIO flags support a small set of
refactorings has been done in order to keep the platform_data-based
systems support, make the code more readable and the alterations - clearer.
In general the whole changes might be considered as the plat- and dt-
specific code split up. In the first patch we unpinned the platform-specific
method of GPIO-chip probing. The second patch introduces a new initial_state
value field into the "gpiomux" structure. The third one is responsible for
GPIO request loop isoltaing into a dedicated function. At this stage common
it is a common function for both dt- and plat- code paths. Finally last
patch introduces a full dt-based GPIOs request method, which uses
gpiod_get_from_of_node() method in order to parse the corresponding dt GPIO
specifiers with their falgs. The last patch does what we inteded this patchset
for in the first place - adds the full dt-GPIO specifiers support.

Changelog v2
- Remove fallback pattern when selecting the dt- or plat-based code paths.
(Cause the patch "i2c-mux-gpio: Return an error if no onfig data found"
removal.)
- Use a dedicated initial_state variable to keep the initial channels selector
state. (Causes the patch "i2c-mux-gpio: Save initial channel number to the
idle" removal.)
- Mention open-drain, open-source flags in the patchset descriptions.


Serge Semin (3):
i2c-mux-gpio: Unpin a platform-based device initialization
i2c-mux-gpio: Unpin the platform-specific GPIOs request code
i2c-mux-gpio: Create of-based GPIOs request method

drivers/i2c/muxes/i2c-mux-gpio.c | 226 ++++++++++++++++++++-----------
1 file changed, 146 insertions(+), 80 deletions(-)

--
2.21.0

\
 
 \ /
  Last update: 2019-04-26 01:22    [W:0.350 / U:0.564 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site