lkml.org 
[lkml]   [2019]   [Apr]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/5] i2c-mux-gpio: Split plat- and dt-specific code up
Date
The main idea of this patchset was to add the dt-based GPIOs support
in i2c-mux-gpio driver. In particular we needed to have the full GPIOs
specifier being handled including the dt-flags like GPIO_ACTIVE_HIGH,
GPIO_ACTIVE_LOW, etc. Due to using a legacy GPIO interface the former
driver implementation didn't provide this ability.

On the way of adding the full dt-GPIO flags support a small set of
refactorings has been done in order to keep the platform_data-based
systems support, make the code more readable and the alterations - clearer.
In general the whole changes might be considered as the plat- and dt-
specific code split up. In first patch we unpinned the platform-specific
method of GPIO-chip probing. The second patch makes the driver to return
an error if of-based (last resort path) failed to retrieve the driver
private data. The next three patches is the sequence of initial channel
info retrieval, platform_data-specific code isolation and finally full
dt-based GPIOs request method introduction. The last patch does what
we inteded this patchset for in the first place - adds the full dt-GPIO
specifiers support.


Serge Semin (5):
i2c-mux-gpio: Unpin a platform-based device initialization
i2c-mux-gpio: Return an error if no config data found
i2c-mux-gpio: Save initial channel number to the idle data field
i2c-mux-gpio: Unpin the platform-specific GPIOs request code
i2c-mux-gpio: Create of-based GPIOs request method

drivers/i2c/muxes/i2c-mux-gpio.c | 224 ++++++++++++++++++++-----------
1 file changed, 146 insertions(+), 78 deletions(-)

--
2.21.0

\
 
 \ /
  Last update: 2019-04-24 14:35    [W:0.251 / U:0.136 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site