lkml.org 
[lkml]   [2022]   [Apr]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v4 RESEND 5/9] serial: omap: remove redundant code in rs485_config
Date
In uart_set_rs485_config() the serial core already clamps the RTS delays.
It also assigns the passed serial_rs485 struct to the uart port.

So remove these tasks from the drivers rs485_config() function to avoid
redundancy.

Signed-off-by: Lino Sanfilippo <LinoSanfilippo@gmx.de>
---
drivers/tty/serial/omap-serial.c | 13 +++----------
1 file changed, 3 insertions(+), 10 deletions(-)

diff --git a/drivers/tty/serial/omap-serial.c b/drivers/tty/serial/omap-serial.c
index 8d5ffa196097..46f4d4cacb6e 100644
--- a/drivers/tty/serial/omap-serial.c
+++ b/drivers/tty/serial/omap-serial.c
@@ -1336,18 +1336,11 @@ serial_omap_config_rs485(struct uart_port *port, struct serial_rs485 *rs485)
up->ier = 0;
serial_out(up, UART_IER, 0);

- /* Clamp the delays to [0, 100ms] */
- rs485->delay_rts_before_send = min(rs485->delay_rts_before_send, 100U);
- rs485->delay_rts_after_send = min(rs485->delay_rts_after_send, 100U);
-
- /* store new config */
- port->rs485 = *rs485;
-
if (up->rts_gpiod) {
/* enable / disable rts */
- val = (port->rs485.flags & SER_RS485_ENABLED) ?
+ val = (rs485->flags & SER_RS485_ENABLED) ?
SER_RS485_RTS_AFTER_SEND : SER_RS485_RTS_ON_SEND;
- val = (port->rs485.flags & val) ? 1 : 0;
+ val = (rs485->flags & val) ? 1 : 0;
gpiod_set_value(up->rts_gpiod, val);
}

@@ -1358,7 +1351,7 @@ serial_omap_config_rs485(struct uart_port *port, struct serial_rs485 *rs485)
/* If RS-485 is disabled, make sure the THR interrupt is fired when
* TX FIFO is below the trigger level.
*/
- if (!(port->rs485.flags & SER_RS485_ENABLED) &&
+ if (!(rs485->flags & SER_RS485_ENABLED) &&
(up->scr & OMAP_UART_SCR_TX_EMPTY)) {
up->scr &= ~OMAP_UART_SCR_TX_EMPTY;
serial_out(up, UART_OMAP_SCR, up->scr);
--
2.35.1
\
 
 \ /
  Last update: 2022-04-10 12:48    [W:0.086 / U:0.348 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site