[lkml]   [2020]   [May]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v2 0/4] Add support for SCD30 sensor
Following series adds support for Sensirion SCD30 sensor module capable of
measuring carbon dioxide, temperature and relative humidity. CO2 measurements
base on NDIR principle while temperature and relative humidity are measured by
the on board SHT31. As for sensor communication, both I2C and serial interfaces
are supported.

* move asm/byteorder.h towards the bottom of include list
* make channel address names in enum more specific
* add postfixes to defines and extra comments
* drop unneeded i2c include from scd30 header
* break generic command sending function into specialized options
* expose automatic calibration and forced calibration via the same attr
* use SAMP_FREQ to set frequency instead of meas_interval attr
* use CALISCALE to set pressure compensation instead of pressure_comp attr
* use CALIBBIAS to set temperature offset instead of temp_offset attr
* fix order in MAINTAINERS
* drop attribute allowing one to reset sensor
* as we have dt probing drop board file based probing (i2c_device_id)
* merge patches touching related files
* use fwnode API to retrieve interrupt from dt
* fix interrupt-parent spelling
* change binding license
* drop supply from required property

Tomasz Duszynski (4):
iio: chemical: scd30: add core driver
iio: chemical: scd30: add I2C interface driver
iio: chemical: scd30: add serial interface driver
dt-bindings: iio: scd30: add device binding file

Documentation/ABI/testing/sysfs-bus-iio-scd30 | 20 +
.../iio/chemical/sensirion,scd30.yaml | 68 ++
drivers/iio/chemical/Kconfig | 33 +
drivers/iio/chemical/Makefile | 3 +
drivers/iio/chemical/scd30.h | 75 ++
drivers/iio/chemical/scd30_core.c | 764 ++++++++++++++++++
drivers/iio/chemical/scd30_i2c.c | 134 +++
drivers/iio/chemical/scd30_serial.c | 266 ++++++
9 files changed, 1372 insertions(+)
create mode 100644 Documentation/ABI/testing/sysfs-bus-iio-scd30
create mode 100644 Documentation/devicetree/bindings/iio/chemical/sensirion,scd30.yaml
create mode 100644 drivers/iio/chemical/scd30.h
create mode 100644 drivers/iio/chemical/scd30_core.c
create mode 100644 drivers/iio/chemical/scd30_i2c.c
create mode 100644 drivers/iio/chemical/scd30_serial.c


 \ /
  Last update: 2020-05-30 23:39    [W:0.120 / U:0.076 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site