lkml.org 
[lkml]   [2017]   [Jun]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/4] dt-bindings: pwm-backlight: add pwm-delay-us property
Date
From: huang lin <hl@rock-chips.com>

Add a pwm-delay-us property to specify the delay between setting an
initial (non-zero) PWM value and enabling the backlight, and also the
delay between disabling the backlight and setting PWM value to 0.

Signed-off-by: huang lin <hl@rock-chips.com>
Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
---
Changes since v1:
- As suggested by Daniel Thompson
- Do not assume power-on delay and power-off delay will be the same

v1: https://lkml.org/lkml/2017/6/28/219

Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt | 6 ++++++
1 file changed, 6 insertions(+)

diff --git a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt b/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
index 764db86..49b037e 100644
--- a/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
+++ b/Documentation/devicetree/bindings/leds/backlight/pwm-backlight.txt
@@ -17,6 +17,11 @@ Optional properties:
"pwms" property (see PWM binding[0])
- enable-gpios: contains a single GPIO specifier for the GPIO which enables
and disables the backlight (see GPIO binding[1])
+ - pwm-delay-us: delay between setting an initial (non-zero) PWM value and
+ enabling the backlight, and also the delay between disabling
+ the backlight and setting PWM value to 0.
+ The 1st cell is the pre-delay in micro seconds.
+ The 2nd cell is the post-delay in micro seconds.

[0]: Documentation/devicetree/bindings/pwm/pwm.txt
[1]: Documentation/devicetree/bindings/gpio/gpio.txt
@@ -32,4 +37,5 @@ Example:

power-supply = <&vdd_bl_reg>;
enable-gpios = <&gpio 58 0>;
+ pwm-delay-us = <10000 10000>;
};
--
2.9.3
\
 
 \ /
  Last update: 2017-06-30 23:11    [W:0.132 / U:0.928 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site