lkml.org 
[lkml]   [2023]   [Jun]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [v6 0/4] Support pwm/tach driver for aspeed ast26xx
From
On 08/06/2023 04:18, Billy Tsai wrote:
> Unlike the old design that the register setting of the TACH should based
> on the configure of the PWM. In ast26xx, the dependency between pwm and
> tach controller is eliminated and becomes a separate hardware block. One
> is used to provide pwm output and another is used to monitor the frequency
> of the input. Therefore, this patch serials implements them by writing the
> two driver "pwm-aspeed-ast2600.c" and "tach-aspeed-ast2600.c". The former
> is following the pwm subsystem which can apply the existed driver to
> controller the fan(pwm-fan.c), beeper(pwm-beeper.c) and so on. The latter
> is following the sysfs interface of hwmon to creat the node for fan
> monitor.

You like to ignore my comments... How did you implement them? Go one by
one - answer to v4 emails.

Best regards,
Krzysztof

\
 
 \ /
  Last update: 2023-06-08 08:38    [W:0.152 / U:1.052 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site