Messages in this thread | | | Date | Sat, 11 Sep 1999 00:51:33 -0700 | From | tommiy@ozemail ... | Subject | Adaptec 1542 and kernel 2.2.11&12 not working? |
| |
I have a strnage problem and have spent a number of hours investigating but haven't found a solution so I thought I'd try the list.
I have an old aha1542 card thats driving a sony dat drive, with all the scsi options set for module and under kernel 2.2.9 everything works fine as below:-
Configuring Adaptec (SCSI-ID 7) at IO:334, IRQ 11,DMA priority 5 Sep 11 17:21:14 bored kernel: scsi0 : Adaptec 1542 Sep 11 17:21:14 bored kernel: scsi : 1 host. Sep 11 17:21:14 bored kernel: Vendor: SONY Model: SDT-5200 Rev:3.02 Sep 11 17:21:14 bored kernel: Type: Sequential-Access ANSI SCSI revision: 02
However, if I use kernel 2.2.11 or 2.2.12 then it will not find the scsi card at boot time and I cannot convince it to find it at all using modprobe or insmod. Under both of these kernels if i try to use modprobe I get:-
/sbin/modprobe aha1542.o /lib/modules/2.2.12udma/scsi/aha1542.o: init_module: Device or resource busy
I've tried adding parameters to lilo etc but this doesn't resolve what ever is making the above error. However rebooting into kernel 2.2.9 the scsi card loads as a module without a problem.
Any idea's would be appreciated I can't believe that the 1542 driver is broken perhaps its just the module.
Regards
- To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to majordomo@vger.rutgers.edu Please read the FAQ at http://www.tux.org/lkml/
| |