lkml.org 
[lkml]   [2024]   [Apr]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v4 3/3] bus: mhi: host: pci_generic: Add edl callback to enter EDL
On Tue, Apr 23, 2024 at 06:33:37PM +0800, Qiang Yu wrote:
> Some of the MHI modems like SDX65 based ones are capable of entering the EDL
> mode as per the standard triggering mechanism defined in the MHI spec v1.2. So
> let's add a common mhi_pci_generic_edl_trigger() function that triggers the EDL
> mode in the device when user writes to the /sys/bus/mhi/devices/.../trigger_edl
> file.
>
> Signed-off-by: Qiang Yu <quic_qianyu@quicinc.com>

Same comment as previous.

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>

> ---
> drivers/bus/mhi/host/pci_generic.c | 45 ++++++++++++++++++++++++++++++++++++++
> 1 file changed, 45 insertions(+)
>
> diff --git a/drivers/bus/mhi/host/pci_generic.c b/drivers/bus/mhi/host/pci_generic.c
> index 51639bf..c65eaa8 100644
> --- a/drivers/bus/mhi/host/pci_generic.c
> +++ b/drivers/bus/mhi/host/pci_generic.c
> @@ -27,12 +27,16 @@
> #define PCI_VENDOR_ID_THALES 0x1269
> #define PCI_VENDOR_ID_QUECTEL 0x1eac
>
> +#define MHI_EDL_DB 91
> +#define MHI_EDL_COOKIE 0xEDEDEDED
> +
> /**
> * struct mhi_pci_dev_info - MHI PCI device specific information
> * @config: MHI controller configuration
> * @name: name of the PCI module
> * @fw: firmware path (if any)
> * @edl: emergency download mode firmware path (if any)
> + * @edl_trigger: capable of triggering EDL mode in the device (if supported)
> * @bar_num: PCI base address register to use for MHI MMIO register space
> * @dma_data_width: DMA transfer word size (32 or 64 bits)
> * @mru_default: default MRU size for MBIM network packets
> @@ -44,6 +48,7 @@ struct mhi_pci_dev_info {
> const char *name;
> const char *fw;
> const char *edl;
> + bool edl_trigger;
> unsigned int bar_num;
> unsigned int dma_data_width;
> unsigned int mru_default;
> @@ -292,6 +297,7 @@ static const struct mhi_pci_dev_info mhi_qcom_sdx75_info = {
> .name = "qcom-sdx75m",
> .fw = "qcom/sdx75m/xbl.elf",
> .edl = "qcom/sdx75m/edl.mbn",
> + .edl_trigger = true,
> .config = &modem_qcom_v2_mhiv_config,
> .bar_num = MHI_PCI_DEFAULT_BAR_NUM,
> .dma_data_width = 32,
> @@ -302,6 +308,7 @@ static const struct mhi_pci_dev_info mhi_qcom_sdx65_info = {
> .name = "qcom-sdx65m",
> .fw = "qcom/sdx65m/xbl.elf",
> .edl = "qcom/sdx65m/edl.mbn",
> + .edl_trigger = true,
> .config = &modem_qcom_v1_mhiv_config,
> .bar_num = MHI_PCI_DEFAULT_BAR_NUM,
> .dma_data_width = 32,
> @@ -312,6 +319,7 @@ static const struct mhi_pci_dev_info mhi_qcom_sdx55_info = {
> .name = "qcom-sdx55m",
> .fw = "qcom/sdx55m/sbl1.mbn",
> .edl = "qcom/sdx55m/edl.mbn",
> + .edl_trigger = true,
> .config = &modem_qcom_v1_mhiv_config,
> .bar_num = MHI_PCI_DEFAULT_BAR_NUM,
> .dma_data_width = 32,
> @@ -928,6 +936,40 @@ static void health_check(struct timer_list *t)
> mod_timer(&mhi_pdev->health_check_timer, jiffies + HEALTH_CHECK_PERIOD);
> }
>
> +static int mhi_pci_generic_edl_trigger(struct mhi_controller *mhi_cntrl)
> +{
> + void __iomem *base = mhi_cntrl->regs;
> + void __iomem *edl_db;
> + int ret = 0;

No need to initialize 'ret'.

- Mani

> + u32 val;
> +
> + ret = mhi_device_get_sync(mhi_cntrl->mhi_dev);
> + if (ret) {
> + dev_err(mhi_cntrl->cntrl_dev, "Failed to wakeup the device\n");
> + return ret;
> + }
> +
> + pm_wakeup_event(&mhi_cntrl->mhi_dev->dev, 0);
> + mhi_cntrl->runtime_get(mhi_cntrl);
> +
> + ret = mhi_get_channel_doorbell_offset(mhi_cntrl, &val);
> + if (ret)
> + goto err_get_chdb;
> +
> + edl_db = base + val + (8 * MHI_EDL_DB);
> +
> + mhi_cntrl->write_reg(mhi_cntrl, edl_db + 4, upper_32_bits(MHI_EDL_COOKIE));
> + mhi_cntrl->write_reg(mhi_cntrl, edl_db, lower_32_bits(MHI_EDL_COOKIE));
> +
> + mhi_soc_reset(mhi_cntrl);
> +
> +err_get_chdb:
> + mhi_cntrl->runtime_put(mhi_cntrl);
> + mhi_device_put(mhi_cntrl->mhi_dev);
> +
> + return ret;
> +}
> +
> static int mhi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
> {
> const struct mhi_pci_dev_info *info = (struct mhi_pci_dev_info *) id->driver_data;
> @@ -962,6 +1004,9 @@ static int mhi_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
> mhi_cntrl->runtime_put = mhi_pci_runtime_put;
> mhi_cntrl->mru = info->mru_default;
>
> + if (info->edl_trigger)
> + mhi_cntrl->edl_trigger = mhi_pci_generic_edl_trigger;
> +
> if (info->sideband_wake) {
> mhi_cntrl->wake_get = mhi_pci_wake_get_nop;
> mhi_cntrl->wake_put = mhi_pci_wake_put_nop;
> --
> 2.7.4
>
>

--
மணிவண்ணன் சதாசிவம்

\
 
 \ /
  Last update: 2024-04-25 16:01    [W:5.543 / U:0.008 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site