Messages in this thread | | | Date | Fri, 21 Jul 2023 10:18:17 +0100 | From | Conor Dooley <> | Subject | Re: [PATCH v5 1/2] dt-bindings: net: motorcomm: Add pad driver strength cfg |
| |
On Thu, Jul 20, 2023 at 06:00:15PM +0200, Andrew Lunn wrote: > > + motorcomm,rx-clk-drv-microamp: > > + description: | > > + drive strength of rx_clk rgmii pad. > > + The YT8531 RGMII LDO voltage supports 1.8V/3.3V, and the LDO voltage can > > + be configured with hardware pull-up resistors to match the SOC voltage > > + (usually 1.8V). > > + The software can read the registers to obtain the LDO voltage and configure > > + the legal drive strength(curren). > > + ===================================================== > > + | voltage | curren Available (uA) | > > current has a t. > > > + ===================================================== > > + | voltage | curren Available (uA) | > > Reviewed-by: Andrew Lunn <andrew@lunn.ch>
With the fixup, Reviewed-by: Conor Dooley <conor.dooley@microchip.com>
Thanks, Conor.
[unhandled content-type:application/pgp-signature] | |