lkml.org 
[lkml]   [2023]   [Jul]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
SubjectRe: [PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC
From


-------- 原始信息 --------
主题: Re: [PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC
From: Conor Dooley <conor@kernel.org>
收件人: Guo Samin <samin.guo@starfivetech.com>, Rob Herring <robh+dt@kernel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>, Paul Walmsley <paul.walmsley@sifive.com>, Palmer Dabbelt <palmer@dabbelt.com>, Albert Ou <aou@eecs.berkeley.edu>, Hal Feng <hal.feng@starfivetech.com>, linux-kernel@vger.kernel.org, linux-riscv@lists.infradead.org, devicetree@vger.kernel.org, netdev@vger.kernel.org
日期: 2023/7/21

>
>
> On 21 July 2023 03:09:19 IST, Guo Samin <samin.guo@starfivetech.com> wrote:
>>
>>
>> -------- 原始信息 --------
>> 主题: Re: [PATCH v1 0/2] Add ethernet nodes for StarFive JH7110 SoC
>> From: Conor Dooley <conor@kernel.org>
>> 收件人: Conor Dooley <conor@kernel.org>, Rob Herring <robh+dt@kernel.org>, Krzysztof Kozlowski <krzysztof.kozlowski+dt@linaro.org>, Paul Walmsley <paul.walmsley@sifive.com>, Palmer Dabbelt <palmer@dabbelt.com>, Albert Ou <aou@eecs.berkeley.edu>, Hal Feng <hal.feng@starfivetech.com>, linux-kernel@vger.kernel.org, linux-riscv@lists.infradead.org, devicetree@vger.kernel.org, netdev@vger.kernel.org, Samin Guo <samin.guo@starfivetech.com>
>> 日期: 2023/7/21
>>
>>> From: Conor Dooley <conor.dooley@microchip.com>
>>>
>>> On Fri, 14 Jul 2023 18:45:19 +0800, Samin Guo wrote:
>>>> This series adds ethernet nodes for StarFive JH7110 RISC-V SoC,
>>>> and has been tested on StarFive VisionFive-2 v1.2A and v1.3B SBC boards.
>>>>
>>>> The first patch adds ethernet nodes for jh7110 SoC, the second patch
>>>> adds ethernet nodes for visionfive 2 SBCs.
>>>>
>>>> This series relies on xingyu's syscon patch[1].
>>>> For more information and support, you can visit RVspace wiki[2].
>>>>
>>>> [...]
>>>
>>> Applied to riscv-dt-for-next, thanks!
>>>
>>> [1/2] riscv: dts: starfive: jh7110: Add ethernet device nodes
>>> https://git.kernel.org/conor/c/1ff166c97972
>>> [2/2] riscv: dts: starfive: visionfive 2: Add configuration of gmac and phy
>>> https://git.kernel.org/conor/c/b15a73c358d1
>>>
>>> Thanks,
>>> Conor.
>>
>>
>> Hi Conor,
>>
>> Thank you so much!
>>
>> There is a question about the configuration of phy that I would like to consult you.
>>
>> Latest on motorcomm PHY V5[1]: Follow Rob Herring's advice
>> motorcomm,rx-xxx-driver-strength Changed to motorcomm,rx-xxx-drv-microamp .
>> V5 has already received a reviewed-by from Andrew Lunn, and it should not change again.
>>
>> Should I submit another pacthes based on riscv-dt-for-next?
>
> Huh, dtbs_check passed for these patches,
> I didn't realise changes to the motorcomm stuff
> were a dep. for this. I'll take a look later.
>
Hi Conor,

Thanks for taking the time to follow this.

After discussing with HAL, I have prepared the code and considered adding the following patch to
Motorcomm's patchsetes v6. (To fix some spelling errors in v5[1])
which will then send patches based on linux-next. What do you think? @Andrew @Conor

[1] https://patchwork.kernel.org/project/netdevbpf/cover/20230720111509.21843-1-samin.guo@starfivetech.com



--- a/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2-v1.3b.dts
+++ b/arch/riscv/boot/dts/starfive/jh7110-starfive-visionfive-2-v1.3b.dts
@@ -28,8 +28,8 @@
motorcomm,tx-clk-adj-enabled;
motorcomm,tx-clk-100-inverted;
motorcomm,tx-clk-1000-inverted;
- motorcomm,rx-clk-driver-strength = <3970>;
- motorcomm,rx-data-driver-strength = <2910>;
+ motorcomm,rx-clk-drv-microamp = <3970>;
+ motorcomm,rx-data-drv-microamp = <2910>;
rx-internal-delay-ps = <1500>;
tx-internal-delay-ps = <1500>;
};
@@ -37,8 +37,8 @@
&phy1 {
motorcomm,tx-clk-adj-enabled;
motorcomm,tx-clk-100-inverted;
- motorcomm,rx-clk-driver-strength = <3970>;
- motorcomm,rx-data-driver-strength = <2910>;
+ motorcomm,rx-clk-drv-microamp = <3970>;
+ motorcomm,rx-data-drv-microamp = <2910>;
rx-internal-delay-ps = <300>;
tx-internal-delay-ps = <0>;
};

Best regards,
Samin

>>
>> [1] https://patchwork.kernel.org/project/netdevbpf/cover/20230720111509.21843-1-samin.guo@starfivetech.com
>>
>>
>> Best regards,
>> Samin

\
 
 \ /
  Last update: 2023-07-21 09:28    [W:0.050 / U:0.696 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site