Messages in this thread Patch in this message | | | From | Andrew Jeffery <> | Subject | [PATCH] mmc: sdhci-of-aspeed: Turn down a phase correction warning | Date | Mon, 7 Jun 2021 11:00:20 +0930 |
| |
The card timing and the bus frequency are not changed atomically with respect to calls to the set_clock() callback in the driver. The result is the driver sees a transient state where there's a mismatch between the two and thus the inputs to the phase correction calculation formula are garbage.
Switch from dev_warn() to dev_dbg() to avoid noise in the normal case, though the change does make bad configurations less likely to be noticed.
Reported-by: Joel Stanley <joel@jms.id.au> Signed-off-by: Andrew Jeffery <andrew@aj.id.au> --- drivers/mmc/host/sdhci-of-aspeed.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/mmc/host/sdhci-of-aspeed.c b/drivers/mmc/host/sdhci-of-aspeed.c index d001c51074a0..e4665a438ec5 100644 --- a/drivers/mmc/host/sdhci-of-aspeed.c +++ b/drivers/mmc/host/sdhci-of-aspeed.c @@ -150,7 +150,7 @@ static int aspeed_sdhci_phase_to_tap(struct device *dev, unsigned long rate_hz, tap = div_u64(phase_period_ps, prop_delay_ps); if (tap > ASPEED_SDHCI_NR_TAPS) { - dev_warn(dev, + dev_dbg(dev, "Requested out of range phase tap %d for %d degrees of phase compensation at %luHz, clamping to tap %d\n", tap, phase_deg, rate_hz, ASPEED_SDHCI_NR_TAPS); tap = ASPEED_SDHCI_NR_TAPS; -- 2.30.2
| |