lkml.org 
[lkml]   [2020]   [Sep]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V5 1/4] arm64: dts: qcom: sc7180: Improve the pin config settings for CTS and TX
Hi,

On Thu, Sep 10, 2020 at 5:55 AM satya priya <skakit@codeaurora.org> wrote:
>
> Remove output-high from CTS and TX as this is not really required. During
> bringup to fix transfer failures this was added to match with console uart
> settings. Probably some boot loader config was missing then. As it is
> working fine now, remove it.
>
> Signed-off-by: satya priya <skakit@codeaurora.org>
> Reviewed-by: Akash Asthana <akashast@codeaurora.org>
> Reviewed-by: Matthias Kaehlcke <mka@chromium.org>
> ---
> Changes in V4:
> - This is newly added in V4 to separate the improvements in pin settings
> and wakeup related changes.
>
> Changes in V5:
> - As per Doug's comment configured pull-down for CTS pin as earlier.
>
> arch/arm64/boot/dts/qcom/sc7180-idp.dts | 10 ++++------
> 1 file changed, 4 insertions(+), 6 deletions(-)

Looks fine to me. Slight nit that this only applies to the IDP board
but ${SUBJECT} makes it sound as if this applies to all sc7180. I
wouldn't spin just for that, though. If Bjorn agrees, he can always
adjust the subject when applying.

Reviewed-by: Douglas Anderson <dianders@chromium.org>

\
 
 \ /
  Last update: 2020-09-10 23:02    [W:1.863 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site