lkml.org 
[lkml]   [2020]   [Feb]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH net-next v2] net: phy: dp83867: Add speed optimization feature
From
Date
Russell

On 2/18/20 10:25 AM, Russell King - ARM Linux admin wrote:
> On Fri, Feb 14, 2020 at 12:31:52PM -0600, Dan Murphy wrote:
>> Grygorii
>>
>> On 2/14/20 12:32 PM, Grygorii Strashko wrote:
>>> I think it's good idea to have this message as just wrong cable might be
>>> used.
>>>
>>> But this notifier make no sense in it current form - it will produce
>>> noise in case of forced 100m/10M.
>>>
>>> FYI. PHY sequence to update link:
>>> phy_state_machine()
>>> |-phy_check_link_status()
>>>   |-phy_link_down/up()
>>>     |- .phy_link_change()->phy_link_change()
>>>     |-adjust_link() ----> netdev callback
>>> |-phydev->drv->link_change_notify(phydev);
>>>
>>> So, log output has to be done or in .read_status() or
>>> some info has to be saved in .read_status() and then re-used in
>>> .link_change_notify().
>>>
>> OK I will try to find a way to give some sort of message.
> How do you know the speed that the PHY downshifted to?

The DP83867 has a register PHYSTS where BIT 15:14 indicate the speed
that the PHY negotiated.

In the same register BIT 13 indicates the duplex mode.

> If the speed and duplex are available in some PHY specific status
> register, then one way you can detect downshift is to decode the
> negotiated speed/duplex from the advertisements (specifically the LPA
> read from the registers and the advertisement that we should be
> advertising - some PHYs modify their registers when downshifting) and
> check whether it matches the negotiated parameters in the PHY
> specific status register.
>
> Alternatively, if the PHY modifies the advertisement register on
> downshift, comparing the advertisement register with what it should
> be will tell you if downshift has occurred.

The ISR register BIT 5 indicates if a downshift occurred or not. So we
can indicate that the PHY downshifted but there is no cause in the
registers bit field.  My concern for this bit though is the register is
clear on read so all other interrupts are lost if we only read to check
downshift.  And the link_change_notifier is called before the interrupt
ACK call back.  We could call the interrupt function and get the
downshift status but again it will clear the interrupt register and any
other statuses may be lost.

Dan


\
 
 \ /
  Last update: 2020-02-18 17:43    [W:0.244 / U:0.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site