lkml.org 
[lkml]   [2020]   [Jan]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/2] spi: cadence-xspi: Add support for the Cadence XSPI controller
Date
Driver for Cadence xSPI flash controller.

Command processing
Driver uses STIG work mode to communicate with flash memories.
In this mode, controller sends low-level instructions to memory.
Each instruction is 128-bit width. There is special instruction
DataSequence which carries information about data phase.
Driver uses Slave DMA interface to transfer data as only this
interface can be used in STIG work mode.

PHY initialization
The initialization of PHY module in Cadence XSPI controller
is done by driving external pin-strap signals to controller.
Next, driver runs PHY training to find optimal value of
read_dqs_delay parameter. Controller checks device discovery
status and if it's completed and with no error PHY training
passes.

Konrad Kociolek (2):
Add dt-bindings schema for Cadence XSPI controller driver
Add support for Cadence XSPI controller

.../devicetree/bindings/spi/cdns,xspi.yaml | 164 ++++
drivers/spi/Kconfig | 11 +
drivers/spi/Makefile | 1 +
drivers/spi/spi-cadence-xspi.c | 895 +++++++++++++++++++++
4 files changed, 1071 insertions(+)
create mode 100644 Documentation/devicetree/bindings/spi/cdns,xspi.yaml
create mode 100644 drivers/spi/spi-cadence-xspi.c

--
2.7.4

\
 
 \ /
  Last update: 2020-01-20 13:55    [W:0.045 / U:0.456 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site