lkml.org 
[lkml]   [2019]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] usb: usb251xb: Lock i2c-bus segment the hub resides
On Sat, Apr 27, 2019 at 10:10:27AM +0300, Serge Semin wrote:
> On Sat, Apr 27, 2019 at 09:00:42AM +0200, Greg Kroah-Hartman wrote:
> > On Fri, Apr 26, 2019 at 01:46:50PM +0300, Serge Semin wrote:
> > > SMBus slave configuration is activated by CFG_SEL[1:0]=0x1 pins
> > > state. This is the mode the hub is supposed to be to let this driver
> > > work correctly. But a race condition might happen right after reset
> > > is cleared due to CFG_SEL[0] pin being multiplexed with SMBus SCL
> > > function. In case if the reset pin is handled by a i2c GPIO expander,
> > > which is also placed at the same i2c-bus segment as the usb251x
> > > SMB-interface connected to, then the hub reset clearance might
> > > cause the CFG_SEL[0] being latched in unpredictable state. So
> > > sometimes the hub configuration mode might be 0x1 (as expected),
> > > but sometimes being 0x0, which doesn't imply to have the hub SMBus-slave
> > > interface activated and consequently causes this driver failure.
> > >
> > > In order to fix the problem we must make sure the GPIO-reset chip doesn't
> > > reside the same i2c-bus segment as the SMBus-interface of the hub. If
> > > it doesn't, we can safely block the segment for the time the reset is
> > > cleared to prevent anyone generating a traffic at the i2c-bus SCL lane
> > > connected to the CFG_SEL[0] pin. But if it does, nothing we can do, so
> > > just return an error. If we locked the i2c-bus segment and tried to
> > > communicate with the GPIO-expander, it would cause a deadlock. If we didn't
> > > lock the i2c-bus segment, it would randomly cause the CFG_SEL[0] bit flip.
> > >
> > > Signed-off-by: Serge Semin <fancer.lancer@gmail.com>
> > > Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
> >
> > I signed off on this? Where? When?
> >
> > never add a s-o-b line that you did not create, that implies a legal
> > agreement.
> >
>
> Ah, shit. Sorry. I should have added Acked-by. That's what I was going to do,
> since you already added the first version of this into linux-next tree. But
> apparently copy-pasted and left as is...

If I have already applied a patch, I can't apply it again (or a
different version.) You need to send a fix-up patch for the reported
issue, not a whole new one as I can not go back in time and rewrite
history.

thanks,

greg k-h

\
 
 \ /
  Last update: 2019-04-27 09:32    [W:2.554 / U:0.036 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site