lkml.org 
[lkml]   [2019]   [Apr]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2] usb: usb251xb: Lock i2c-bus segment the hub resides
On Fri, Apr 26, 2019 at 01:46:50PM +0300, Serge Semin wrote:
> SMBus slave configuration is activated by CFG_SEL[1:0]=0x1 pins
> state. This is the mode the hub is supposed to be to let this driver
> work correctly. But a race condition might happen right after reset
> is cleared due to CFG_SEL[0] pin being multiplexed with SMBus SCL
> function. In case if the reset pin is handled by a i2c GPIO expander,
> which is also placed at the same i2c-bus segment as the usb251x
> SMB-interface connected to, then the hub reset clearance might
> cause the CFG_SEL[0] being latched in unpredictable state. So
> sometimes the hub configuration mode might be 0x1 (as expected),
> but sometimes being 0x0, which doesn't imply to have the hub SMBus-slave
> interface activated and consequently causes this driver failure.
>
> In order to fix the problem we must make sure the GPIO-reset chip doesn't
> reside the same i2c-bus segment as the SMBus-interface of the hub. If
> it doesn't, we can safely block the segment for the time the reset is
> cleared to prevent anyone generating a traffic at the i2c-bus SCL lane
> connected to the CFG_SEL[0] pin. But if it does, nothing we can do, so
> just return an error. If we locked the i2c-bus segment and tried to
> communicate with the GPIO-expander, it would cause a deadlock. If we didn't
> lock the i2c-bus segment, it would randomly cause the CFG_SEL[0] bit flip.
>
> Signed-off-by: Serge Semin <fancer.lancer@gmail.com>
> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

I signed off on this? Where? When?

never add a s-o-b line that you did not create, that implies a legal
agreement.

greg k-h

\
 
 \ /
  Last update: 2019-04-27 09:00    [W:0.062 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site