lkml.org 
[lkml]   [2019]   [Nov]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v3 1/1] drivers: watchdog: stm32_iwdg: set WDOG_HW_RUNNING at probe
Date
If the watchdog hardware is already enabled during the boot process,
when the Linux watchdog driver loads, it should start/reset the watchdog
and tell the watchdog framework. As a result, ping can be generated from
the watchdog framework (if CONFIG_WATCHDOG_HANDLE_BOOT_ENABLED is set),
until the userspace watchdog daemon takes over control

Fixes:4332d113c66a ("watchdog: Add STM32 IWDG driver")

Signed-off-by: Christophe Roullier <christophe.roullier@st.com>
---
Changes since v2:
According to Guenter
removed intermediate variable

I've tested some config and it is working as expected:
Watchdog enable in Uboot + HANDLE_BOOT_ENABLE is not set + daemon watchdog in userland ON ==> No reset IWDG2
Watchdog enable in Uboot + HANDLE_BOOT_ENABLE is not set ==> Reset IWDG2
Watchdog enable in Uboot + HANDLE_BOOT_ENABLE=y ==> No reset IWDG2
Watchdog enable in Uboot + HANDLE_BOOT_ENABLE=y + daemon watchdog in userland ON puis OFF ==> Reset IWDG2
Watchdog disable in Uboot + HANDLE_BOOT_ENABLE is not set ==> No reset IWDG2
Watchdog disable in Uboot + HANDLE_BOOT_ENABLE=y ==> No reset IWDG2
Watchdog disable in Uboot + HANDLE_BOOT_ENABLE=y + daemon watchdog in userland ON ==> No reset IWDG2
Watchdog disable in Uboot + HANDLE_BOOT_ENABLE=y + daemon watchdog in userland ON puis OFF ==> Reset IWDG2

Thanks,
Christophe

drivers/watchdog/stm32_iwdg.c | 18 ++++++++++++++++++
1 file changed, 18 insertions(+)

diff --git a/drivers/watchdog/stm32_iwdg.c b/drivers/watchdog/stm32_iwdg.c
index a3a329011a06..25188d6bbe15 100644
--- a/drivers/watchdog/stm32_iwdg.c
+++ b/drivers/watchdog/stm32_iwdg.c
@@ -262,6 +262,24 @@ static int stm32_iwdg_probe(struct platform_device *pdev)
watchdog_set_nowayout(wdd, WATCHDOG_NOWAYOUT);
watchdog_init_timeout(wdd, 0, dev);

+ /*
+ * In case of CONFIG_WATCHDOG_HANDLE_BOOT_ENABLED is set
+ * (Means U-Boot/bootloaders leaves the watchdog running)
+ * When we get here we should make a decision to prevent
+ * any side effects before user space daemon will take care of it.
+ * The best option, taking into consideration that there is no
+ * way to read values back from hardware, is to enforce watchdog
+ * being run with deterministic values.
+ */
+ if (IS_ENABLED(CONFIG_WATCHDOG_HANDLE_BOOT_ENABLED)) {
+ ret = stm32_iwdg_start(wdd);
+ if (ret)
+ return ret;
+
+ /* Make sure the watchdog is serviced */
+ set_bit(WDOG_HW_RUNNING, &wdd->status);
+ }
+
ret = devm_watchdog_register_device(dev, wdd);
if (ret)
return ret;
--
2.17.1
\
 
 \ /
  Last update: 2019-11-22 14:23    [W:0.134 / U:0.276 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site