[lkml]   [2018]   [Nov]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [Letux-kernel] [PATCH RFC] bluetooth: add uart h4 devices via serdev/devicetree
Hi Andreas,

>>>>> Am 12.11.2018 um 21:59 schrieb Andreas Kemnade <>:
>>>>> On Sun, 11 Nov 2018 03:46:48 +0100
>>>>> Sebastian Reichel <> wrote:
>>>>>> On Sun, Nov 11, 2018 at 12:20:34AM +0100, Andreas Kemnade wrote:
>>>>>>> This is a first try to be able to use h4 devices specified in
>>>>>>> the devicetree, so you do not need to call hciattach and
>>>>>>> it can be automatically probed.
>>>>>>> Of course, proper devicetree bindings documentation is
>>>>>>> missing. And also you would extend that by regulator/
>>>>>>> enable gpio settings.
>>>>>>> But before proceeding further it should be checked if the
>>>>>>> general way of doing things is right.
>>>>>>> Signed-off-by: Andreas Kemnade <>
>>>>>>> ---
>>>>>> Patch looks good to me, just one note
>>>>> I found one thing myself:
>>>>> Shouldn't we have a generic compatible string like "generic-h4".
>>>>> ehci-platform.c has for example:
>>>>> { .compatible = "generic-ehci", },
>>>> There might be differences in h4 compatible devices (e.g. default
>>>> baud rate) so that I would not bet there a "generic-h4" suffices
>>>> in the long run.
>> It will not because that doesn't define clocks, resets, gpios,
>> supplies, etc. and the interactions of all those.
> well, we need a simple supply being on when the device is on.
> Nothing more.
>>> My suggestion is to use this in DT:
>>> compatible = "wi2wi,w2cbw003-bluetooth", "<something generic>";
> That would be my slight preference here.
>>> The driver can start with supporting just the generic compatible
>>> string. If somebody finds some incompatible differences, the driver
>>> can add a custom handler for the wi2wi chip without breaking DT
>>> ABI.
>> Any idea how many H4 devices there are? Somehow I doubt there are that
>> many to be unmanageable.
> Well, many devices are h4 devices with some more or less important
> vendor-specific commands. Well, "hciattach any" uses simple h4 protocol.
> those firmware download commands and they have their own drivers.
> Most devices I had used bluetooth uart from the command line with, were
> simple enough. The other question is whether those devices will run a
> modern kernel.
> No strong opinion here.

doing the firmware load from user space via some magic tool is no longer going to work smoothly. It will be actually almost impossible with serdev. However I did post btuart.c driver which is pretty much just plain H:4. You would still somehow define the default baudraute since just picking 115200 is not always going to work.

Btw. I see nothing standing in the way of merging btuart.c driver and then go from there. Either I dig this out and submit or someone else does.



 \ /
  Last update: 2018-11-14 08:52    [W:0.066 / U:88.888 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site