lkml.org 
[lkml]   [2018]   [Nov]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v3 0/2] irqchip: Add support for Renesas RZ/N1 GPIO interrupt multiplexer
Date
On RZ/N1 devices, there are lots of GPIO interrupts that are multiplexed before
getting to the GIC interrupt controller. Other than the multiplexing, there is
no other logic applied to the signals.

The multiplexing cannot be handled dynamically because there is another CPU that
runs firmware. It's likely that the firmware will use some of these GPIO
interrupts and so we don't want them to move around.

Signed-off-by: Phil Edworthy <phil.edworthy@renesas.com>
---
v3:
- Use 'interrupt-map' DT property to map the interrupts, this is very similar
to PCIe MSI. The only difference is that we need to get hold of the interrupt
specifier for the interupts coming into the irqmux.
I had completely messed up the use of 'interrupt-map' in v2... oops.
- Do not use a chained interrupt controller.
v2:
- Split DT bindings into separate patch.
- Use interrupt-map to allow the GPIO controller info to be specified
as part of the irq.
- Don't show status in binding examples.
- Don't show the soc/board split in binding doc.
- Renamed struct and funcs from 'girq' to a more comprehenisble 'irqmux'.

Phil Edworthy (2):
dt-bindings/interrupt-controller: rzn1: Add RZ/N1 gpio irq mux binding
irqchip: Add support for Renesas RZ/N1 GPIO interrupt multiplexer

.../interrupt-controller/renesas,rzn1-mux.txt | 73 +++++++
drivers/irqchip/Kconfig | 9 +
drivers/irqchip/Makefile | 1 +
drivers/irqchip/rzn1-irq-mux.c | 205 ++++++++++++++++++
4 files changed, 288 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interrupt-controller/renesas,rzn1-mux.txt
create mode 100644 drivers/irqchip/rzn1-irq-mux.c

--
2.17.1

\
 
 \ /
  Last update: 2018-11-13 14:10    [W:0.108 / U:0.276 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site