Messages in this thread Patch in this message | | | From | Peter Rosin <> | Subject | [PATCH] ARM: dts: at91: add envelope detector mux to the Axentia TSE-850 | Date | Fri, 17 Mar 2017 23:24:46 +0100 |
| |
The envelope detector can analyze 6 different signals, selectable with a mux controlled by three gpio pins.
Signed-off-by: Peter Rosin <peda@axentia.se> ---
Hi!
This patch makes use of the mux subsystem and a couple of drivers available in linux-next since a week or two. The stuff this depends on has relevant acks, specifically on the DT bindings, so the bindings should be stable and not cause trouble for this patch. Which is why I thought I'd try to get this in for v4.12-rc1 along with that mux subsystem series.
Please consider applying.
Cheers, peda
arch/arm/boot/dts/at91-tse850-3.dts | 29 ++++++++++++++++++++++++++++- 1 file changed, 28 insertions(+), 1 deletion(-)
diff --git a/arch/arm/boot/dts/at91-tse850-3.dts b/arch/arm/boot/dts/at91-tse850-3.dts index 669a2c6bdefc..7a68805a4eb5 100644 --- a/arch/arm/boot/dts/at91-tse850-3.dts +++ b/arch/arm/boot/dts/at91-tse850-3.dts @@ -86,16 +86,43 @@ #io-channel-cells = <1>; }; - envelope-detector { + env_det: envelope-detector { compatible = "axentia,tse850-envelope-detector"; io-channels = <&dac 0>; io-channel-names = "dac"; + #io-channel-cells = <1>; interrupt-parent = <&pioA>; interrupts = <3 IRQ_TYPE_EDGE_RISING>; interrupt-names = "comp"; }; + mux: mux-controller { + compatible = "mux-gpio"; + #mux-control-cells = <0>; + + mux-gpios = <&pioA 0 GPIO_ACTIVE_HIGH>, + <&pioA 1 GPIO_ACTIVE_HIGH>, + <&pioA 2 GPIO_ACTIVE_HIGH>; + idle-state = <0>; + }; + + envelope-detector-mux { + compatible = "io-channel-mux"; + io-channels = <&env_det 0>; + io-channel-names = "parent"; + + mux-controls = <&mux>; + + channels = "", "", + "sync-1", + "in", + "out", + "sync-2", + "sys-reg", + "ana-reg"; + }; + leds { compatible = "gpio-leds"; -- 2.1.4
| |