lkml.org 
[lkml]   [2016]   [Mar]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v5 13/26] memory: omap-gpmc: Support general purpose input for WAITPINs
Hi Roger,

On Fri, 19 Feb 2016 23:15:35 +0200
Roger Quadros <rogerq@ti.com> wrote:

> OMAPs can have 2 to 4 WAITPINs that can be used as general purpose
> input if not used for memory wait state insertion.
>
> The first user will be the OMAP NAND chip to get the NAND
> read/busy status using gpiolib.

Just a comment on this approach. Why do you need to exposed native R/B
pins as GPIOs? I mean, other NAND controllers are supporting R/B
detection using dedicated logic, and they do not exposed those pins a
plain GPIOs. Have you considered adding another property (rb-native ?)
to deal with this case instead of emulating a GPIO controller?
Side note: I added an rb-gpios property in my sunxi-nand DT binding
because in some cases, the board design forces us to use a plain GPIO.

Anyway, I realize I'm quite late to review this, and I don't want to
delay even more the inclusion of those patches, so I leave the decision
to the MTD and TI maintainers.

Best Regards,

Boris

>
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> ---
> .../bindings/memory-controllers/omap-gpmc.txt | 3 +
> drivers/memory/Kconfig | 1 +
> drivers/memory/omap-gpmc.c | 115 ++++++++++++++++++---
> 3 files changed, 107 insertions(+), 12 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt b/Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt
> index 704be93..8113a52 100644
> --- a/Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt
> +++ b/Documentation/devicetree/bindings/memory-controllers/omap-gpmc.txt
> @@ -32,6 +32,9 @@ Required properties:
> bootloader) are used for the physical address decoding.
> As this will change in the future, filling correct
> values here is a requirement.
> + - gpio-controller: The GPMC driver implements a GPIO controller for the
> + GPMC WAIT pins that can be used as general purpose inputs.
> + 0 maps to GPMC_WAIT0 pin.
>
> Timing properties for child nodes. All are optional and default to 0.
>
> diff --git a/drivers/memory/Kconfig b/drivers/memory/Kconfig
> index 6f31546..bca24c6 100644
> --- a/drivers/memory/Kconfig
> +++ b/drivers/memory/Kconfig
> @@ -51,6 +51,7 @@ config TI_EMIF
>
> config OMAP_GPMC
> bool
> + select GPIOLIB
> help
> This driver is for the General Purpose Memory Controller (GPMC)
> present on Texas Instruments SoCs (e.g. OMAP2+). GPMC allows
> diff --git a/drivers/memory/omap-gpmc.c b/drivers/memory/omap-gpmc.c
> index 6c8d85e..f67e5695 100644
> --- a/drivers/memory/omap-gpmc.c
> +++ b/drivers/memory/omap-gpmc.c
> @@ -21,6 +21,7 @@
> #include <linux/spinlock.h>
> #include <linux/io.h>
> #include <linux/module.h>
> +#include <linux/gpio/driver.h>
> #include <linux/interrupt.h>
> #include <linux/irqdomain.h>
> #include <linux/platform_device.h>
> @@ -237,6 +238,7 @@ struct gpmc_device {
> struct device *dev;
> int irq;
> struct irq_chip irq_chip;
> + struct gpio_chip gpio_chip;
> };
>
> static struct irq_domain *gpmc_irq_domain;
> @@ -2034,10 +2036,69 @@ err:
> return ret;
> }
>
> +static int gpmc_gpio_get_direction(struct gpio_chip *chip, unsigned offset)
> +{
> + return 1; /* we're input only */
> +}
> +
> +static int gpmc_gpio_direction_input(struct gpio_chip *chip, unsigned offset)
> +{
> + return 0; /* we're input only */
> +}
> +
> +static int gpmc_gpio_direction_output(struct gpio_chip *chip, unsigned offset,
> + int value)
> +{
> + return -EINVAL; /* we're input only */
> +}
> +
> +static void gpmc_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
> +{
> +}
> +
> +static int gpmc_gpio_get(struct gpio_chip *chip, unsigned offset)
> +{
> + u32 reg;
> +
> + offset += 8;
> +
> + reg = gpmc_read_reg(GPMC_STATUS) & BIT(offset);
> +
> + return !!reg;
> +}
> +
> +static int gpmc_gpio_init(struct gpmc_device *gpmc)
> +{
> + int ret;
> +
> + gpmc->gpio_chip.parent = gpmc->dev;
> + gpmc->gpio_chip.owner = THIS_MODULE;
> + gpmc->gpio_chip.label = DEVICE_NAME;
> + gpmc->gpio_chip.ngpio = gpmc_nr_waitpins;
> + gpmc->gpio_chip.get_direction = gpmc_gpio_get_direction;
> + gpmc->gpio_chip.direction_input = gpmc_gpio_direction_input;
> + gpmc->gpio_chip.direction_output = gpmc_gpio_direction_output;
> + gpmc->gpio_chip.set = gpmc_gpio_set;
> + gpmc->gpio_chip.get = gpmc_gpio_get;
> + gpmc->gpio_chip.base = -1;
> +
> + ret = gpiochip_add(&gpmc->gpio_chip);
> + if (ret < 0) {
> + dev_err(gpmc->dev, "could not register gpio chip: %d\n", ret);
> + return ret;
> + }
> +
> + return 0;
> +}
> +
> +static void gpmc_gpio_exit(struct gpmc_device *gpmc)
> +{
> + gpiochip_remove(&gpmc->gpio_chip);
> +}
> +
> static int gpmc_probe_dt(struct platform_device *pdev)
> {
> int ret;
> - struct device_node *child;
> const struct of_device_id *of_id =
> of_match_device(gpmc_dt_ids, &pdev->dev);
>
> @@ -2065,6 +2126,14 @@ static int gpmc_probe_dt(struct platform_device *pdev)
> return ret;
> }
>
> + return 0;
> +}
> +
> +static int gpmc_probe_dt_children(struct platform_device *pdev)
> +{
> + int ret;
> + struct device_node *child;
> +
> for_each_available_child_of_node(pdev->dev.of_node, child) {
>
> if (!child->name)
> @@ -2074,6 +2143,9 @@ static int gpmc_probe_dt(struct platform_device *pdev)
> ret = gpmc_probe_onenand_child(pdev, child);
> else
> ret = gpmc_probe_generic_child(pdev, child);
> +
> + if (ret)
> + return ret;
> }
>
> return 0;
> @@ -2083,6 +2155,11 @@ static int gpmc_probe_dt(struct platform_device *pdev)
> {
> return 0;
> }
> +
> +static int gpmc_probe_dt_children(struct platform_device *pdev)
> +{
> + return 0;
> +}
> #endif
>
> static int gpmc_probe(struct platform_device *pdev)
> @@ -2129,6 +2206,15 @@ static int gpmc_probe(struct platform_device *pdev)
> return -EINVAL;
> }
>
> + if (pdev->dev.of_node) {
> + rc = gpmc_probe_dt(pdev);
> + if (rc)
> + return rc;
> + } else {
> + gpmc_cs_num = GPMC_CS_NUM;
> + gpmc_nr_waitpins = GPMC_NR_WAITPINS;
> + }
> +
> pm_runtime_enable(&pdev->dev);
> pm_runtime_get_sync(&pdev->dev);
>
> @@ -2154,29 +2240,33 @@ static int gpmc_probe(struct platform_device *pdev)
> GPMC_REVISION_MINOR(l));
>
> gpmc_mem_init();
> + rc = gpmc_gpio_init(gpmc);
> + if (rc)
> + goto gpio_init_failed;
>
> rc = gpmc_setup_irq(gpmc);
> if (rc) {
> dev_err(gpmc->dev, "gpmc_setup_irq failed\n");
> - goto fail;
> + goto setup_irq_failed;
> }
>
> - if (!pdev->dev.of_node) {
> - gpmc_cs_num = GPMC_CS_NUM;
> - gpmc_nr_waitpins = GPMC_NR_WAITPINS;
> - }
> -
> - rc = gpmc_probe_dt(pdev);
> + rc = gpmc_probe_dt_children(pdev);
> if (rc < 0) {
> - dev_err(gpmc->dev, "failed to probe DT parameters\n");
> - gpmc_free_irq(gpmc);
> - goto fail;
> + dev_err(gpmc->dev, "failed to probe DT children\n");
> + goto dt_children_failed;
> }
>
> return 0;
>
> -fail:
> +dt_children_failed:
> + gpmc_free_irq(gpmc);
> +setup_irq_failed:
> + gpmc_gpio_exit(gpmc);
> +gpio_init_failed:
> + gpmc_mem_exit();
> pm_runtime_put_sync(&pdev->dev);
> + pm_runtime_disable(&pdev->dev);
> +
> return rc;
> }
>
> @@ -2185,6 +2275,7 @@ static int gpmc_remove(struct platform_device *pdev)
> struct gpmc_device *gpmc = platform_get_drvdata(pdev);
>
> gpmc_free_irq(gpmc);
> + gpmc_gpio_exit(gpmc);
> gpmc_mem_exit();
> pm_runtime_put_sync(&pdev->dev);
> pm_runtime_disable(&pdev->dev);



--
Boris Brezillon, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com

\
 
 \ /
  Last update: 2016-03-07 11:21    [W:0.298 / U:0.248 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site