lkml.org 
[lkml]   [2016]   [Nov]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/3] pinctrl: sunxi: Fix PIN_CONFIG_BIAS_PULL_{DOWN,UP} argument
Date
According to pinconf-generic.h, the argument for
PIN_CONFIG_BIAS_PULL_{DOWN,UP} is non-zero if the bias is enabled
with a pull up/down resistor, zero if it is directly connected
to VDD or ground.

Since Allwinner hardware uses a weak pull resistor internally,
the argument should be 1.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
---
drivers/pinctrl/sunxi/pinctrl-sunxi.c | 6 +++++-
1 file changed, 5 insertions(+), 1 deletion(-)

diff --git a/drivers/pinctrl/sunxi/pinctrl-sunxi.c b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
index e199d95af8c0..e04edda8629d 100644
--- a/drivers/pinctrl/sunxi/pinctrl-sunxi.c
+++ b/drivers/pinctrl/sunxi/pinctrl-sunxi.c
@@ -291,12 +291,16 @@ static unsigned long *sunxi_pctrl_build_pin_config(struct device_node *node,

if (sunxi_pctrl_has_bias_prop(node)) {
int pull = sunxi_pctrl_parse_bias_prop(node);
+ int arg = 0;
if (pull < 0) {
ret = pull;
goto err_free;
}

- pinconfig[idx++] = pinconf_to_config_packed(pull, 0);
+ if (pull != PIN_CONFIG_BIAS_DISABLE)
+ arg = 1; /* hardware uses weak pull resistors */
+
+ pinconfig[idx++] = pinconf_to_config_packed(pull, arg);
}


--
2.10.2
\
 
 \ /
  Last update: 2016-11-11 03:46    [W:0.199 / U:0.072 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site