lkml.org 
[lkml]   [2016]   [Oct]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 00/13] Revamp Semtech SX150x driver
Date
Hello,

I am working with a hardware design utilizing SX1506 GPIO expander
(actually it uses 1503, but they seem to be the same from SW's point
of view) and following are the pathches I had to make in order to be
able to succesfully use part's driver from upstream kernel.

I am pretty certain I did not do any of the DT bindings in a proper
way, so I am more than happy to change all of that, or, due to the
fact I don't use any of those bindings in my usecase, drop them
alltogether.

Thank you,
Andrey Smirnov

Andrey Smirnov (13):
gpio-sx150x: Remove 'gpio_base' from pdata
gpio-sx150x: Remove 'irq_summary' parameter
gpio-sx150x: Remove 'irq_base' parameter
gpio-sx150x: Replace 'io_polarity' with DT binding
bindings: gpio-sx150x: Document "semtech,io-polarity" binding
gpio-sx150x: Replace "io_pull*_ena" with DT bindings
bindings: gpio-sx150x: Document "semtech,io-pull*" bindings
gpio-sx150x: Replace 'reset_during_probe" with DT binding
bindings: gpio-sx150x: Document "semtech,reset-during-probe" bindings
gpio-sx150x: Replace 'oscio_is_gpio' with DT binding
bindings: gpio-sx150x: Document "semtech,oscio-is-gpo" binding
gpio-sx150x: Remove struct sx150x_platform_data
gpio-sx150x: Pass device type in DT match table

.../devicetree/bindings/gpio/gpio-sx150x.txt | 29 ++++
drivers/gpio/gpio-sx150x.c | 184 +++++++++------------
2 files changed, 105 insertions(+), 108 deletions(-)

--
2.5.5

\
 
 \ /
  Last update: 2016-10-17 16:27    [W:0.102 / U:0.196 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site