[lkml]   [2015]   [Jul]   [28]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v2 0/22] On-demand device probing

I have a problem with the panel on my Tegra Chromebook taking longer
than expected to be ready during boot (Stéphane Marchesin reported what
is basically the same issue in [0]), and have looked into ordered
probing as a better way of solving this than moving nodes around in the
DT or playing with initcall levels and linking order.

While reading the thread [1] that Alexander Holler started with his
series to make probing order deterministic, it occurred to me that it
should be possible to achieve the same by probing devices as they are
referenced by other devices.

This basically reuses the information that is already implicit in the
probe() implementations, saving us from refactoring existing drivers or
adding information to DTBs.

During review of v1 of this series Linus Walleij suggested that it
should be the device driver core to make sure that dependencies are
ready before probing a device. I gave this idea a try [2] but Mark Brown
pointed out to the logic duplication between the resource acquisition
and dependency discovery code paths (though I think it's fairly minor).

To address that code duplication I experimented with Arnd's devm_probe
[3] concept of having drivers declare their dependencies instead of
acquiring them during probe, and while it worked [4], I don't think we
end up winning anything when compared to just probing devices on-demand
from resource getters.

One remaining objection is to the "sprinkling" of calls to
fwnode_ensure_device() in the resource getters of each subsystem, but I
think it's the right thing to do given that the storage of resources is
currently subsystem-specific.

We could avoid the above by moving resource storage into the core, but I
don't think there's a compelling case for that.

I have tested this on boards with Tegra, iMX.6, Exynos and OMAP SoCs,
and these patches were enough to eliminate all the deferred probes
(except one in PandaBoard because omap_dma_system doesn't have a
firmware node as of yet).

With this series I get the kernel to output to the panel in 0.5s,
instead of 2.8s.








Changes in v2:
- Move delay to platform.c
- Use set_primary_fwnode()
- Use of_node_full_name()
- Move the logic for finding a platform device from its firmware node to
of/platform.c as it's not needed for ACPI nodes.
- Add acpi_dev_get_device()
- Add fwnode_ensure_device() so the mechanism for probing devices on
demand is independent of the firmware format.
- Acquire regulator device lock before returning from regulator_dev_lookup()

Tomeu Vizoso (22):
platform: delay device-driver matches until late_initcall
of/platform: Set fwnode field for new devices
device property: add fwnode_get_name()
of/platform: add of_platform_device_find()
ACPI: add acpi_dev_get_device()
device property: add fwnode_ensure_device()
gpio: Probe GPIO drivers on demand
gpio: Probe pinctrl devices on demand
regulator: core: Reduce critical area in _regulator_get
regulator: core: Probe regulators on demand
drm: Probe panels on demand
drm/tegra: Probe dpaux devices on demand
i2c: core: Probe i2c master devices on demand
pwm: Probe PWM chip devices on demand
backlight: Probe backlight devices on demand
usb: phy: Probe phy devices on demand
clk: Probe clk providers on demand
pinctrl: Probe pinctrl devices on demand
phy: core: Probe phy providers on demand
dma: of: Probe DMA controllers on demand
power-supply: Probe power supplies on demand
ASoC: core: Probe components on demand

drivers/base/platform.c | 28 +++++++++++
drivers/base/property.c | 73 +++++++++++++++++++++++++++
drivers/clk/clk.c | 3 ++
drivers/dma/of-dma.c | 2 +
drivers/gpio/gpiolib-of.c | 4 ++
drivers/gpu/drm/drm_panel.c | 2 +
drivers/gpu/drm/tegra/dpaux.c | 2 +
drivers/i2c/i2c-core.c | 2 +
drivers/of/platform.c | 61 +++++++++++++++++++++++
drivers/phy/phy-core.c | 2 +
drivers/pinctrl/devicetree.c | 1 +
drivers/power/power_supply_core.c | 2 +
drivers/pwm/core.c | 2 +
drivers/regulator/core.c | 99 +++++++++++++++++++++----------------
drivers/usb/phy/phy.c | 2 +
drivers/video/backlight/backlight.c | 2 +
include/linux/acpi.h | 10 ++++
include/linux/of_platform.h | 1 +
include/linux/property.h | 4 ++
sound/soc/soc-core.c | 6 ++-
20 files changed, 264 insertions(+), 44 deletions(-)


 \ /
  Last update: 2015-07-28 15:41    [W:0.158 / U:0.352 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site