lkml.org 
[lkml]   [2015]   [Jul]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[RESEND: PATCH v1] mtd: nand: davinci: add support for 4K page size nand devices.
Date
K2L EVM uses NAND with 4K page size. This patch add support for
ECC layout requires to enable Micron MT29F16G08ADBCAH4 NAND available
on this EVM.

Signed-off-by: Murali Karicheri <m-karicheri2@ti.com>
Signed-off-by: Hao Zhang <hzhang@ti.com>
---
- Resend after subscribing to linux-mtd mailing list. I assume
no one has seen this on this mailing list as I don't have any
comments. So re-sending.
- v1 - Remove the comment as well from the code as now 4K page
is supported
drivers/mtd/nand/davinci_nand.c | 42 +++++++++++++++++++++++++++++------------
1 file changed, 30 insertions(+), 12 deletions(-)

diff --git a/drivers/mtd/nand/davinci_nand.c b/drivers/mtd/nand/davinci_nand.c
index feb6d18..90b177b 100644
--- a/drivers/mtd/nand/davinci_nand.c
+++ b/drivers/mtd/nand/davinci_nand.c
@@ -520,6 +520,31 @@ static struct nand_ecclayout hwecc4_2048 = {
},
};

+/* An ECC layout for using 4-bit ECC with large-page (4096bytes) flash,
+ * storing ten ECC bytes plus the manufacturer's bad block marker byte,
+ * and not overlapping the default BBT markers.
+ */
+static struct nand_ecclayout hwecc4_4096 = {
+ .eccbytes = 80,
+ .eccpos = {
+ /* at the end of spare sector */
+ 48, 49, 50, 51, 52, 53, 54, 55, 56, 57,
+ 58, 59, 60, 61, 62, 63, 64, 65, 66, 67,
+ 68, 69, 70, 71, 72, 73, 74, 75, 76, 77,
+ 78, 79, 80, 81, 82, 83, 84, 85, 86, 87,
+ 88, 89, 90, 91, 92, 93, 94, 95, 96, 97,
+ 98, 99, 100, 101, 102, 103, 104, 105, 106, 107,
+ 108, 109, 110, 111, 112, 113, 114, 115, 116, 117,
+ 118, 119, 120, 121, 122, 123, 124, 125, 126, 127,
+ },
+ .oobfree = {
+ /* 2 bytes at offset 0 hold manufacturer badblock markers */
+ {.offset = 2, .length = 46, },
+ /* 5 bytes at offset 8 hold BBT markers */
+ /* 8 bytes at offset 16 hold JFFS2 clean markers */
+ },
+};
+
#if defined(CONFIG_OF)
static const struct of_device_id davinci_nand_of_match[] = {
{.compatible = "ti,davinci-nand", },
@@ -796,18 +821,11 @@ static int nand_davinci_probe(struct platform_device *pdev)
info->chip.ecc.mode = NAND_ECC_HW_OOB_FIRST;
goto syndrome_done;
}
-
- /* 4KiB page chips are not yet supported. The eccpos from
- * nand_ecclayout cannot hold 80 bytes and change to eccpos[]
- * breaks userspace ioctl interface with mtd-utils. Once we
- * resolve this issue, NAND_ECC_HW_OOB_FIRST mode can be used
- * for the 4KiB page chips.
- *
- * TODO: Note that nand_ecclayout has now been expanded and can
- * hold plenty of OOB entries.
- */
- dev_warn(&pdev->dev, "no 4-bit ECC support yet "
- "for 4KiB-page NAND\n");
+ if (chunks == 8) {
+ info->ecclayout = hwecc4_4096;
+ info->chip.ecc.mode = NAND_ECC_HW_OOB_FIRST;
+ goto syndrome_done;
+ }
ret = -EIO;
goto err;

--
1.9.1


\
 
 \ /
  Last update: 2015-07-13 22:21    [W:0.097 / U:1.224 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site