lkml.org 
[lkml]   [2015]   [Oct]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] pinctrl: uniphier: set input-enable before pin-muxing
Date
While IECTRL is disabled, input signals are pulled-down internally.
If pin-muxing is set up first, glitch signals (Low to High transition)
might be input to hardware blocks.

Bad case scenario:
[1] The hardware block is already running before pinctrl is handled.
(the reset is de-asserted by default or by a firmware, for example)
[2] The pin-muxing is set up. The input signals to hardware block
are pulled-down by the chip-internal biasing.
[3] The pins are input-enabled. The signals from the board reach the
hardware block.

Actually, one invalid character is input to the UART blocks for such
SoCs as PH1-LD4, PH1-sLD8, where UART devices start to run at the
power on reset.

To avoid such problems, pins should be input-enabled before muxing.

Fixes: 6e9088920258 ("pinctrl: UniPhier: add UniPhier pinctrl core support")
Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
Reported-by: Dai Okamura <okamura.dai@socionext.com>
---

Hi Linus,

If it is not too late, please apply this fix for Linux 4.3.

Thanks,
Masahiro


drivers/pinctrl/uniphier/pinctrl-uniphier-core.c | 10 +++++++---
1 file changed, 7 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/uniphier/pinctrl-uniphier-core.c b/drivers/pinctrl/uniphier/pinctrl-uniphier-core.c
index 918f3b6..589872c 100644
--- a/drivers/pinctrl/uniphier/pinctrl-uniphier-core.c
+++ b/drivers/pinctrl/uniphier/pinctrl-uniphier-core.c
@@ -539,6 +539,12 @@ static int uniphier_pmx_set_one_mux(struct pinctrl_dev *pctldev, unsigned pin,
unsigned reg, reg_end, shift, mask;
int ret;

+ /* some pins need input-enabling */
+ ret = uniphier_conf_pin_input_enable(pctldev,
+ &pctldev->desc->pins[pin], 1);
+ if (ret)
+ return ret;
+
reg = UNIPHIER_PINCTRL_PINMUX_BASE + pin * mux_bits / 32 * reg_stride;
reg_end = reg + reg_stride;
shift = pin * mux_bits % 32;
@@ -563,9 +569,7 @@ static int uniphier_pmx_set_one_mux(struct pinctrl_dev *pctldev, unsigned pin,
return ret;
}

- /* some pins need input-enabling */
- return uniphier_conf_pin_input_enable(pctldev,
- &pctldev->desc->pins[pin], 1);
+ return 0;
}

static int uniphier_pmx_set_mux(struct pinctrl_dev *pctldev,
--
1.9.1


\
 
 \ /
  Last update: 2015-10-20 10:41    [W:0.206 / U:0.324 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site