lkml.org 
[lkml]   [2015]   [Jan]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 3/5] ARM: dts: dra7-evm: Add extcon nodes for USB
Date
On this EVM, the USB cable state has to be determined via the
ID pin tied to a GPIO line. We use the gpio-usb-extcon driver
to read the ID pin and the extcon framework to forward
the USB cable state information to the USB driver so the
controller can be configured in the right mode (host/peripheral).

Gets USB peripheral mode to work on this EVM.

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
arch/arm/boot/dts/dra7-evm.dts | 31 +++++++++++++++++++++++++++++++
1 file changed, 31 insertions(+)

diff --git a/arch/arm/boot/dts/dra7-evm.dts b/arch/arm/boot/dts/dra7-evm.dts
index 10b725c..47d9a06 100644
--- a/arch/arm/boot/dts/dra7-evm.dts
+++ b/arch/arm/boot/dts/dra7-evm.dts
@@ -26,6 +26,16 @@
regulator-max-microvolt = <3300000>;
};

+ extcon_usb1: extcon_usb1 {
+ compatible = "linux,extcon-usb";
+ id-gpio = <&pcf_gpio_21 1 GPIO_ACTIVE_HIGH>;
+ };
+
+ extcon_usb2: extcon_usb2 {
+ compatible = "linux,extcon-usb";
+ id-gpio = <&pcf_gpio_21 2 GPIO_ACTIVE_HIGH>;
+ };
+
vtt_fixed: fixedregulator-vtt {
compatible = "regulator-fixed";
regulator-name = "vtt_fixed";
@@ -391,6 +401,19 @@
};
};
};
+
+ pcf_gpio_21: gpio@21 {
+ compatible = "ti,pcf8575";
+ reg = <0x21>;
+ lines-initial-states = <0x1408>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ interrupt-parent = <&gpio6>;
+ interrupts = <11 IRQ_TYPE_EDGE_FALLING>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+ };
+
};

&i2c2 {
@@ -520,6 +543,14 @@
};
};

+&omap_dwc3_1 {
+ extcon = <&extcon_usb1>;
+};
+
+&omap_dwc3_2 {
+ extcon = <&extcon_usb2>;
+};
+
&usb1 {
dr_mode = "peripheral";
pinctrl-names = "default";
--
2.1.0


\
 
 \ /
  Last update: 2015-01-19 19:01    [W:0.752 / U:0.980 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site