[lkml]   [2014]   [Apr]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [rfc]pwm: add BCM2835 PWM driver
On 04/08/2014 05:02 PM, Tim Kryger wrote:
> On Thu, Apr 3, 2014 at 6:44 AM, Bart Tanghe <> wrote:
>> need some recommendation
>> the memory mapped io registers of the bcm2835 pwm hardware are spreaded
>> over the memory mapped io
>> gpio config 0x20200004 - clk config 0x201010A0 - pwm configuration 0x2020C000
>> to handle this, I've used the base address of the memory mapped io
>> so I can use positive offsets
> So the registers for this PWM are located in three distinct memory regions?
>> +struct bcm2835_pwm_chip {
>> + struct pwm_chip chip;
>> + struct device *dev;
>> + int channel;
>> + void __iomem *mmio;
> One pointer isn't going to be enough. You need three.
> I suggest renaming the first and adding two more:
> void __iomem *base_pwm;
> void __iomem *base_clk;
> void __iomem *base_alt;

Sorry, I forgot about this patch. One comment here; the PWM driver can't
touch the clock or alt registers; those should be owned by the clock
driver, and the driver for whatever alt is (pinmux - don't recall what
it's touching there).

 \ /
  Last update: 2014-04-09 03:41    [W:0.064 / U:3.084 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site