Messages in this thread | | | Date | Tue, 11 Nov 2014 10:01:56 -0800 | From | Florian Fainelli <> | Subject | Re: [PATCH 00/22] net: phy: refactoring and Micrel features |
| |
On 11/11/2014 10:00 AM, Johan Hovold wrote: > On Tue, Nov 11, 2014 at 12:49:36PM -0500, David Miller wrote: >> 22 patches is just too much, sorry. >> >> Please reduce this down to something closer to ~10 or so patches. >> >> If necessary you can do two series, submit the first 10 and then >> when that's reviewed and accepted submit the second set. > > No problem. The three driver-registration patches are really > self-contained and could be reviewed and applied separately, and then I > split the remaining ones where I add the device-type abstraction, that > is:
Sounds like a reasonable plan to me. Thanks!
> > Series 1: > net: phy: add module_phy_driver macro > net: phy: replace phy_driver_register calls > net: phy: replace phy_drivers_register calls > > Series 2: > dt/bindings: fix documentation of ethernet-phy compatible property > net: phy: micrel: fix config_intr error handling > net: phy: micrel: use BIT macro > net: phy: micrel: refactor broadcast disable > net: phy: micrel: disable broadcast for KSZ8081/KSZ8091 > net: phy: micrel: add led-mode sanity check > net: phy: micrel: refactor led-mode error handling > net: phy: micrel: clean up led-mode setup > net: phy: micrel: enable led-mode for KSZ8081/KSZ8091 > > Series 3 (submitted after review of Series 2): > net: phy: add static data field to struct phy_driver > net: phy: micrel: add device-type abstraction > net: phy: micrel: parse of nodes at probe > net: phy: micrel: add has-broadcast-disable flag to type data > net: phy: micrel: add generic rmii-ref-clk-sel support > net: phy: micrel: add support for rmii_ref_clk_sel to KSZ8081/KSZ8091 > dt/bindings: add micrel,rmii_ref_clk_sel_25_mhz to eth-phy binding > net: phy: micrel: refactor interrupt config > net: phy: micrel: add copyright entry > net: phy: micrel: use generic config_init for KSZ8021/KSZ8031 > > Thanks, > Johan >
| |