lkml.org 
[lkml]   [2014]   [Nov]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 00/22] net: phy: refactoring and Micrel features
On Tue, Nov 11, 2014 at 12:49:36PM -0500, David Miller wrote:
> 22 patches is just too much, sorry.
>
> Please reduce this down to something closer to ~10 or so patches.
>
> If necessary you can do two series, submit the first 10 and then
> when that's reviewed and accepted submit the second set.

No problem. The three driver-registration patches are really
self-contained and could be reviewed and applied separately, and then I
split the remaining ones where I add the device-type abstraction, that
is:

Series 1:
net: phy: add module_phy_driver macro
net: phy: replace phy_driver_register calls
net: phy: replace phy_drivers_register calls

Series 2:
dt/bindings: fix documentation of ethernet-phy compatible property
net: phy: micrel: fix config_intr error handling
net: phy: micrel: use BIT macro
net: phy: micrel: refactor broadcast disable
net: phy: micrel: disable broadcast for KSZ8081/KSZ8091
net: phy: micrel: add led-mode sanity check
net: phy: micrel: refactor led-mode error handling
net: phy: micrel: clean up led-mode setup
net: phy: micrel: enable led-mode for KSZ8081/KSZ8091

Series 3 (submitted after review of Series 2):
net: phy: add static data field to struct phy_driver
net: phy: micrel: add device-type abstraction
net: phy: micrel: parse of nodes at probe
net: phy: micrel: add has-broadcast-disable flag to type data
net: phy: micrel: add generic rmii-ref-clk-sel support
net: phy: micrel: add support for rmii_ref_clk_sel to KSZ8081/KSZ8091
dt/bindings: add micrel,rmii_ref_clk_sel_25_mhz to eth-phy binding
net: phy: micrel: refactor interrupt config
net: phy: micrel: add copyright entry
net: phy: micrel: use generic config_init for KSZ8021/KSZ8031

Thanks,
Johan


\
 
 \ /
  Last update: 2014-11-11 19:41    [W:0.176 / U:0.688 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site