lkml.org 
[lkml]   [2013]   [May]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Date
Subject[47/94] i2c: designware: always clear interrupts before enabling them
3.2.46-rc1 review patch.  If anyone has any objections, please let me know.

------------------

From: Mika Westerberg <mika.westerberg@linux.intel.com>

commit 2a2d95e9d6d29e726cc294b65391917ed2e32bf4 upstream.

If the I2C bus is put to a low power state by an ACPI method it might pull
the SDA line low (as its power is removed). Once the bus is put to full
power state again, the SDA line is pulled back to high. This transition
looks like a STOP condition from the controller point-of-view which sets
STOP detected bit in its status register causing the driver to fail
subsequent transfers.

Fix this by always clearing all interrupts before we start a transfer.

Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>
Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
---
drivers/i2c/busses/i2c-designware-core.c | 3 ++-
1 file changed, 2 insertions(+), 1 deletion(-)

--- a/drivers/i2c/busses/i2c-designware-core.c
+++ b/drivers/i2c/busses/i2c-designware-core.c
@@ -349,7 +349,8 @@ static void i2c_dw_xfer_init(struct dw_i
/* Enable the adapter */
dw_writel(dev, 1, DW_IC_ENABLE);

- /* Enable interrupts */
+ /* Clear and enable interrupts */
+ i2c_dw_clear_int(dev);
dw_writel(dev, DW_IC_INTR_DEFAULT_MASK, DW_IC_INTR_MASK);
}



\
 
 \ /
  Last update: 2013-05-28 06:42    [W:0.603 / U:0.048 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site