lkml.org 
[lkml]   [2012]   [Jan]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
Subject[RFC PATCH 0/2] MFD and GPIO for STA2X11
These two patches introduce multi-function device and GPIO support for
the STA2X11 I/O Hub. It's an RFC for both as explained below.

- I think the MFD driver is ok. This MFD_STA2X11 config symbol is
autoselected by CONFIG_STA2X11, which is pending in the
"x86: initial support for sta2x11" patch, for which I need to send V2
later today, with some minor fixes. Similarly, <asm/sta2x11.h> is
not upstream yet, so I'll need to resend later, I suppose.

- The GPIO patch has a quirk: I chose to register a single irq chip
for 128 interrupts but the generic irq_chip only support 32 interrupts.
I'm sure the hack I did (request the irq descs myself) is not good, but
what is the best approach here? Using 4 generic irq chips or defining
my own, non-generic one?

Thanks a lot
/alessandro

Alessandro Rubini (2):
mfd: Add driver for STA2X11 MFD block
gpio: add STA2X11 GPIO block

drivers/gpio/Kconfig | 9 +
drivers/gpio/Makefile | 1 +
drivers/gpio/gpio-sta2x11.c | 380 +++++++++++++++++++++++++++++++
drivers/mfd/Kconfig | 6 +
drivers/mfd/Makefile | 1 +
drivers/mfd/sta2x11-mfd.c | 470 +++++++++++++++++++++++++++++++++++++++
include/linux/mfd/sta2x11-mfd.h | 186 +++++++++++++++
7 files changed, 1053 insertions(+), 0 deletions(-)
create mode 100644 drivers/gpio/gpio-sta2x11.c
create mode 100644 drivers/mfd/sta2x11-mfd.c
create mode 100644 include/linux/mfd/sta2x11-mfd.h

--
1.7.7.2


\
 
 \ /
  Last update: 2012-01-26 16:55    [W:0.376 / U:0.268 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site