lkml.org 
[lkml]   [2010]   [Sep]   [16]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [lm-sensors] [PATCH 1/2] hwmon: (adm1031) Replace update_rate sysfs attribute with update_interval
On Thu, 16 Sep 2010 12:42:43 -0300, Henrique de Moraes Holschuh wrote:
> On Thu, 16 Sep 2010, Jean Delvare wrote:
> > On Wed, 15 Sep 2010 19:07:14 -0700, Guenter Roeck wrote:
> > > The attribute reflects an interval, not a rate.
> > >
> > > Signed-off-by: Guenter Roeck <guenter.roeck@ericsson.com>
> > > ---
> > > Documentation/hwmon/sysfs-interface | 12 +++++-----
> > > drivers/hwmon/adm1031.c | 43 +++++++++++++++++++---------------
> > > 2 files changed, 30 insertions(+), 25 deletions(-)
> > >
> > > diff --git a/Documentation/hwmon/sysfs-interface b/Documentation/hwmon/sysfs-interface
> > > index ff45d1f..df0cdd2 100644
> > > --- a/Documentation/hwmon/sysfs-interface
> > > +++ b/Documentation/hwmon/sysfs-interface
> > > @@ -91,13 +91,13 @@ name The chip name.
> > > I2C devices get this attribute created automatically.
> > > RO
> > >
> > > -update_rate The rate at which the chip will update readings.
> > > - Unit: millisecond
> > > +update_interval The interval at which the chip or driver will update readings.
> >
> > I think I prefer the original wording. The attribute is really about
> > setting the register refresh rate at the hardware level. The fact that
>
> Only, it doesn't set any rates in the hardware. It sets the period
> (interval).
>
> If the unit of update_rate is changed to Hz, and the driver does
> hardware_timer_milliseconds = 1000/update_rate_Hz, THEN it will be
> correct to call it a rate...

I agree. My point was really only about "chip or driver" vs. "chip".

> I'd rather have it in Hz, actually. I consider that more user-friendly.
> But that's just personal preference.

The problem with Hz is that we need to be able to handle values lower
than 1, and mHz as a unit isn't exactly friendly. I would be very fine
with Hz (especially as we use it for pwmN_freq already) if we didn't
have to support frequencies below 1 Hz. For such low frequencies,
period (or interval) is clearer than frequency IMHO.

--
Jean Delvare


\
 
 \ /
  Last update: 2010-09-16 18:03    [W:0.054 / U:0.780 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site