Messages in this thread | | | Date | Wed, 1 Dec 2010 20:48:42 +0800 | From | Chuanxiao Dong <> | Subject | [PATCH v4 0/4]implement eMMC4.4 standard HW reset feature |
| |
Hi, These are the version 4 patches to implement eMMC4.4 HW reset feature. Host controller can use this feature by trigger RST_n signal. To enable this, byte 162 of EXT_CSD register should be set. HW reset is implemented in mmc core layer and sdhci host layer, and it will be used after each reading/writing/erasing timeout error occures.
change-log: This version change the way to detect timeout error conditions. Added a new routine mmc_handle_timeout_error to do this instead to do this in mmc_wait_for_req. Each timeout read/write/erase command can use this routine to do HW reset.
patch1: enable HW reset capability if card support.
patch2: add two new callback to implement HW reset in mmc core layer. In this patch, routine mmc_handle_timeout_error was added.
patch3: implement hardware_reset callback for sdhci host. A new callback reset_emmc was defined which will be each sdhci host controller to implement separately.
patch4: did a HW reset after each read/write/erase command.
Thanks Chuanxiao
| |