lkml.org 
[lkml]   [2010]   [Oct]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: kgdb errors with serial console
From
Date
Hi Jason,
Perhaps the debugger is timing out because it doesn't get a break point to debug a specific event?

Could you tell me the order in which I should try it?

I think earlier on, when I used the kgdbwait bootarg, it ran and initialized eclipse debugger. Then when I entered the

echo g > /proc/sysrq-trigger

it just activated the debugger correctly because the kgdb_breakpoint method was called in file kgdb.c

So, what should I do to test this? Do I write a small file, and add a call to kgdb_breakpoint in that example file, and then when I execute it, the debugger would get activated?

Is there any other test that I can run, without writing my own example ?

Best regards,

Elvis


\
 
 \ /
  Last update: 2010-10-09 02:09    [W:0.056 / U:0.876 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site