Messages in this thread Patch in this message | | | Date | Thu, 13 Nov 2008 12:14:13 +0100 | From | Nicolas Ferre <> | Subject | [PATCH] mmc: atmel-mci: move atmel-mci.h file to include/linux |
| |
Needed to use the atmel-mci driver in a architecture independent manner.
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com> --- arch/avr32/boards/atngw100/setup.c | 2 +- arch/avr32/boards/atstk1000/atstk1002.c | 2 +- arch/avr32/boards/atstk1000/atstk1003.c | 2 +- arch/avr32/boards/atstk1000/atstk1004.c | 2 +- arch/avr32/include/asm/atmel-mci.h | 39 ------ arch/avr32/mach-at32ap/at32ap700x.c | 2 +- drivers/mmc/host/atmel-mci.c | 2 +- include/linux/atmel-mci.h | 39 ++++++ 8 files changed, 45 insertions(+), 45 deletions(-) delete mode 100644 arch/avr32/include/asm/atmel-mci.h create mode 100644 include/linux/atmel-mci.h
diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c index 6c54580..ca6e1ff 100644 --- a/arch/avr32/boards/atngw100/setup.c +++ b/arch/avr32/boards/atngw100/setup.c @@ -19,8 +19,8 @@ #include <linux/types.h> #include <linux/leds.h> #include <linux/spi/spi.h> +#include <linux/atmel-mci.h> -#include <asm/atmel-mci.h> #include <asm/io.h> #include <asm/setup.h> diff --git a/arch/avr32/boards/atstk1000/atstk1002.c b/arch/avr32/boards/atstk1000/atstk1002.c index 29e5b51..5a6380f 100644 --- a/arch/avr32/boards/atstk1000/atstk1002.c +++ b/arch/avr32/boards/atstk1000/atstk1002.c @@ -16,12 +16,12 @@ #include <linux/types.h> #include <linux/spi/spi.h> #include <linux/spi/at73c213.h> +#include <linux/atmel-mci.h> #include <video/atmel_lcdc.h> #include <asm/io.h> #include <asm/setup.h> -#include <asm/atmel-mci.h> #include <mach/at32ap700x.h> #include <mach/board.h> diff --git a/arch/avr32/boards/atstk1000/atstk1003.c b/arch/avr32/boards/atstk1000/atstk1003.c index be089d7..7b9ceee 100644 --- a/arch/avr32/boards/atstk1000/atstk1003.c +++ b/arch/avr32/boards/atstk1000/atstk1003.c @@ -17,9 +17,9 @@ #include <linux/spi/at73c213.h> #include <linux/spi/spi.h> +#include <linux/atmel-mci.h> #include <asm/setup.h> -#include <asm/atmel-mci.h> #include <mach/at32ap700x.h> #include <mach/board.h> diff --git a/arch/avr32/boards/atstk1000/atstk1004.c b/arch/avr32/boards/atstk1000/atstk1004.c index 248ef23..3ff0498 100644 --- a/arch/avr32/boards/atstk1000/atstk1004.c +++ b/arch/avr32/boards/atstk1000/atstk1004.c @@ -17,11 +17,11 @@ #include <linux/spi/at73c213.h> #include <linux/spi/spi.h> +#include <linux/atmel-mci.h> #include <video/atmel_lcdc.h> #include <asm/setup.h> -#include <asm/atmel-mci.h> #include <mach/at32ap700x.h> #include <mach/board.h> diff --git a/arch/avr32/include/asm/atmel-mci.h b/arch/avr32/include/asm/atmel-mci.h deleted file mode 100644 index 59f3fad..0000000 --- a/arch/avr32/include/asm/atmel-mci.h +++ /dev/null @@ -1,39 +0,0 @@ -#ifndef __ASM_AVR32_ATMEL_MCI_H -#define __ASM_AVR32_ATMEL_MCI_H - -#define ATMEL_MCI_MAX_NR_SLOTS 2 - -struct dma_slave; - -/** - * struct mci_slot_pdata - board-specific per-slot configuration - * @bus_width: Number of data lines wired up the slot - * @detect_pin: GPIO pin wired to the card detect switch - * @wp_pin: GPIO pin wired to the write protect sensor - * - * If a given slot is not present on the board, @bus_width should be - * set to 0. The other fields are ignored in this case. - * - * Any pins that aren't available should be set to a negative value. - * - * Note that support for multiple slots is experimental -- some cards - * might get upset if we don't get the clock management exactly right. - * But in most cases, it should work just fine. - */ -struct mci_slot_pdata { - unsigned int bus_width; - int detect_pin; - int wp_pin; -}; - -/** - * struct mci_platform_data - board-specific MMC/SDcard configuration - * @dma_slave: DMA slave interface to use in data transfers, or NULL. - * @slot: Per-slot configuration data. - */ -struct mci_platform_data { - struct dma_slave *dma_slave; - struct mci_slot_pdata slot[ATMEL_MCI_MAX_NR_SLOTS]; -}; - -#endif /* __ASM_AVR32_ATMEL_MCI_H */ diff --git a/arch/avr32/mach-at32ap/at32ap700x.c b/arch/avr32/mach-at32ap/at32ap700x.c index 813b684..b0ad6da 100644 --- a/arch/avr32/mach-at32ap/at32ap700x.c +++ b/arch/avr32/mach-at32ap/at32ap700x.c @@ -15,8 +15,8 @@ #include <linux/gpio.h> #include <linux/spi/spi.h> #include <linux/usb/atmel_usba_udc.h> +#include <linux/atmel-mci.h> -#include <asm/atmel-mci.h> #include <asm/io.h> #include <asm/irq.h> diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c index 7a3f243..1e97916 100644 --- a/drivers/mmc/host/atmel-mci.c +++ b/drivers/mmc/host/atmel-mci.c @@ -25,8 +25,8 @@ #include <linux/stat.h> #include <linux/mmc/host.h> +#include <linux/atmel-mci.h> -#include <asm/atmel-mci.h> #include <asm/io.h> #include <asm/unaligned.h> diff --git a/include/linux/atmel-mci.h b/include/linux/atmel-mci.h new file mode 100644 index 0000000..2a2213e --- /dev/null +++ b/include/linux/atmel-mci.h @@ -0,0 +1,39 @@ +#ifndef __LINUX_ATMEL_MCI_H +#define __LINUX_ATMEL_MCI_H + +#define ATMEL_MCI_MAX_NR_SLOTS 2 + +struct dma_slave; + +/** + * struct mci_slot_pdata - board-specific per-slot configuration + * @bus_width: Number of data lines wired up the slot + * @detect_pin: GPIO pin wired to the card detect switch + * @wp_pin: GPIO pin wired to the write protect sensor + * + * If a given slot is not present on the board, @bus_width should be + * set to 0. The other fields are ignored in this case. + * + * Any pins that aren't available should be set to a negative value. + * + * Note that support for multiple slots is experimental -- some cards + * might get upset if we don't get the clock management exactly right. + * But in most cases, it should work just fine. + */ +struct mci_slot_pdata { + unsigned int bus_width; + int detect_pin; + int wp_pin; +}; + +/** + * struct mci_platform_data - board-specific MMC/SDcard configuration + * @dma_slave: DMA slave interface to use in data transfers, or NULL. + * @slot: Per-slot configuration data. + */ +struct mci_platform_data { + struct dma_slave *dma_slave; + struct mci_slot_pdata slot[ATMEL_MCI_MAX_NR_SLOTS]; +}; + +#endif /* __LINUX_ATMEL_MCI_H */ -- 1.5.3.7
-- Nicolas Ferre
| |