lkml.org 
[lkml]   [2006]   [Aug]   [21]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Subject[PATCH] libata : Add 40pin "short" cable support, honour drive side speed detection
From
Date
Signed-off-by: Alan Cox <alan@redhat.com>

diff -u --new-file --recursive --exclude-from /usr/src/exclude linux.vanilla-2.6.18-rc4-mm2/drivers/ata/ata_piix.c linux-2.6.18-rc4-mm2/drivers/ata/ata_piix.c
--- linux.vanilla-2.6.18-rc4-mm2/drivers/ata/ata_piix.c 2006-08-21 14:18:52.000000000 +0100
+++ linux-2.6.18-rc4-mm2/drivers/ata/ata_piix.c 2006-08-21 14:21:45.000000000 +0100
@@ -93,7 +93,7 @@
#include <linux/libata.h>

#define DRV_NAME "ata_piix"
-#define DRV_VERSION "2.00ac6"
+#define DRV_VERSION "2.00ac7"

enum {
PIIX_IOCFG = 0x54, /* IDE I/O configuration register */
@@ -560,6 +560,23 @@
MODULE_DEVICE_TABLE(pci, piix_pci_tbl);
MODULE_VERSION(DRV_VERSION);

+struct ich_laptop {
+ u16 device;
+ u16 subvendor;
+ u16 subdevice;
+};
+
+/*
+ * List of laptops that use short cables rather than 80 wire
+ */
+
+static const struct ich_laptop ich_laptop[] = {
+ /* devid, subvendor, subdev */
+ { 0x27DF, 0x0005, 0x0280 }, /* ICH7 on Acer 5602WLMi */
+ /* end marker */
+ { 0, }
+};
+
/**
* piix_pata_cbl_detect - Probe host controller cable detect info
* @ap: Port for which cable detect info is desired
@@ -574,11 +591,21 @@
static void ich_pata_cbl_detect(struct ata_port *ap)
{
struct pci_dev *pdev = to_pci_dev(ap->host_set->dev);
+ const struct ich_laptop *lap = &ich_laptop[0];
u8 tmp, mask;

/* no 80c support in host controller? */
if ((ap->udma_mask & ~ATA_UDMA_MASK_40C) == 0)
goto cbl40;
+
+ /* Check for specials - Acer Aspire 5602WLMi */
+ while (lap->device) {
+ if (lap->device == pdev->device &&
+ lap->subvendor == pdev->subsystem_vendor &&
+ lap->subdevice == pdev->subsystem_device)
+ return ATA_CBL_PATA40_SHORT;
+ lap++;
+ }

/* check BIOS cable detect results */
mask = ap->port_no == 0 ? PIIX_80C_PRI : PIIX_80C_SEC;
diff -u --new-file --recursive --exclude-from /usr/src/exclude linux.vanilla-2.6.18-rc4-mm2/drivers/ata/libata-core.c linux-2.6.18-rc4-mm2/drivers/ata/libata-core.c
--- linux.vanilla-2.6.18-rc4-mm2/drivers/ata/libata-core.c 2006-08-21 14:18:52.000000000 +0100
+++ linux-2.6.18-rc4-mm2/drivers/ata/libata-core.c 2006-08-16 14:26:29.000000000 +0100
@@ -3092,6 +3092,13 @@
*/
if (ap->cbl == ATA_CBL_PATA40)
xfer_mask &= ~(0xF8 << ATA_SHIFT_UDMA);
+ /* Apply drive side cable rule. Unknown or 80 pin cables reported
+ * host side are checked drive side as well. Cases where we know a
+ * 40wire cable is used safely for 80 are not checked here.
+ */
+ if (ata_drive_40wire(dev->id) && (ap->cbl == ATA_CBL_PATA_UNK || ap->cbl == ATA_CBL_PATA80))
+ xfer_mask &= ~(0xF8 << ATA_SHIFT_UDMA);
+

xfer_mask &= ata_pack_xfermask(dev->pio_mask,
dev->mwdma_mask, dev->udma_mask);
diff -u --new-file --recursive --exclude-from /usr/src/exclude linux.vanilla-2.6.18-rc4-mm2/drivers/ata/pata_ali.c linux-2.6.18-rc4-mm2/drivers/ata/pata_ali.c
--- linux.vanilla-2.6.18-rc4-mm2/drivers/ata/pata_ali.c 2006-08-21 14:18:52.000000000 +0100
+++ linux-2.6.18-rc4-mm2/drivers/ata/pata_ali.c 2006-08-16 14:27:10.000000000 +0100
@@ -78,7 +78,7 @@
implement the detect logic */

if (ali_cable_override(pdev))
- return ATA_CBL_PATA80;
+ return ATA_CBL_PATA40_SHORT;

/* Host view cable detect 0x4A bit 0 primary bit 1 secondary
Bit set for 40 pin */
diff -u --new-file --recursive --exclude-from /usr/src/exclude linux.vanilla-2.6.18-rc4-mm2/include/linux/ata.h linux-2.6.18-rc4-mm2/include/linux/ata.h
--- linux.vanilla-2.6.18-rc4-mm2/include/linux/ata.h 2006-08-21 14:18:57.000000000 +0100
+++ linux-2.6.18-rc4-mm2/include/linux/ata.h 2006-08-16 15:55:39.000000000 +0100
@@ -200,8 +200,9 @@
ATA_CBL_NONE = 0,
ATA_CBL_PATA40 = 1,
ATA_CBL_PATA80 = 2,
- ATA_CBL_PATA_UNK = 3,
- ATA_CBL_SATA = 4,
+ ATA_CBL_PATA40_SHORT = 3, /* 40 wire cable to high UDMA spec */
+ ATA_CBL_PATA_UNK = 4,
+ ATA_CBL_SATA = 5,

/* SATA Status and Control Registers */
SCR_STATUS = 0,
@@ -342,6 +343,15 @@
return 0;
}

+static inline int ata_drive_40wire(const u16 *dev_id)
+{
+ if (ata_id_major_version(dev_id) >= 5 && ata_id_is_sata(dev_id))
+ return 0; /* SATA */
+ if (dev_id[93] & 0x4000)
+ return 0; /* 80 wire */
+ return 1;
+}
+
static inline int atapi_cdb_len(const u16 *dev_id)
{
u16 tmp = dev_id[0] & 0x3;
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2006-08-21 21:07    [W:0.075 / U:0.256 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site