lkml.org 
[lkml]   [2004]   [Apr]   [19]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectBadness in get_phy_reg at drivers/ieee1394/ohci1394.c:238
From
Date
Hi folks,

I have reported this around 2.6.5-rc3-mm1 but it never go away.

Kernel Linux blaze 2.6.6-rc1-mm1 #1 Mon Apr 19 04:03:51 EDT 2004 i686
unknown unknown GNU/Linux

Slackware Linux on NForce2 (gigabyte 7NNXP) board with built in ieee1394
adapter.

Dmesg shows this on every boot:

ieee1394: Initialized config rom entry `ip1394'
ohci1394: $Rev: 1203 $ Ben Collins <bcollins@debian.org>
PCI: Setting latency timer of device 0000:00:0d.0 to 64
ohci1394: fw-host0: OHCI-1394 1.1 (PCI): IRQ=[22]
MMIO=[ee084000-ee0847ff] Max Packet=[2048]
PCI: Setting latency timer of device 0000:00:06.0 to 64
PCI: Setting latency timer of device 0000:00:04.0 to 64
eth1: forcedeth.c: subsystem: 01458:e000 bound to 0000:00:04.0
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ehci_hcd 0000:00:02.2: nVidia Corporation nForce2 USB Controller
PCI: Setting latency timer of device 0000:00:02.2 to 64
ehci_hcd 0000:00:02.2: irq 21, pci mem f9897000
ehci_hcd 0000:00:02.2: new USB bus registered, assigned bus number 1
PCI: cache line size of 64 is not supported by device 0000:00:02.2
ehci_hcd 0000:00:02.2: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 6 ports detected
Linux agpgart interface v0.100 (c) Dave Jones
agpgart: Detected NVIDIA nForce2 chipset
agpgart: Maximum main memory to use for agp memory: 941M
agpgart: AGP aperture is 128M @ 0xe0000000
Badness in get_phy_reg at drivers/ieee1394/ohci1394.c:238
Call Trace:
[<f988810e>] get_phy_reg+0x10e/0x120 [ohci1394]
[<f9888e4c>] ohci_devctl+0x5c/0x5d0 [ohci1394]
[<c0106a56>] apic_timer_interrupt+0x1a/0x20
[<c01112d4>] delay_tsc+0x14/0x20
[<f988af1f>] ohci_irq_handler+0x55f/0x800 [ohci1394]
[<c012403f>] do_timer+0xdf/0xf0
[<c01082ea>] handle_IRQ_event+0x3a/0x70
[<c01086b5>] do_IRQ+0xc5/0x1a0
=======================
[<c0106a34>] common_interrupt+0x18/0x20
[<f9888193>] set_phy_reg+0x73/0x120 [ohci1394]
[<f98a6d00>] delayed_reset_bus+0x0/0xd0 [ieee1394]
[<f9888e66>] ohci_devctl+0x76/0x5d0 [ohci1394]
[<f98af3b7>] csr1212_fill_cache+0x97/0x100 [ieee1394]
[<f98a6d00>] delayed_reset_bus+0x0/0xd0 [ieee1394]
[<f98a419c>] hpsb_reset_bus+0x3c/0x40 [ieee1394]
[<f98a6db4>] delayed_reset_bus+0xb4/0xd0 [ieee1394]
[<c0123e54>] run_timer_softirq+0xd4/0x1d0
[<c011fe3d>] __do_softirq+0x7d/0x80
[<c0108fd3>] do_softirq+0x43/0x60
=======================
[<c010873b>] do_IRQ+0x14b/0x1a0
[<c0106a34>] common_interrupt+0x18/0x20
[<c01235f9>] __mod_timer+0x119/0x1a0
[<f9933756>] usb_start_wait_urb+0x86/0xe0 [usbcore]
[<f993381b>] usb_internal_control_msg+0x6b/0x80 [usbcore]
[<f9933650>] timeout_kill+0x0/0x80 [usbcore]
[<f993381b>] usb_internal_control_msg+0x6b/0x80 [usbcore]
[<f99338c6>] usb_control_msg+0x96/0xb0 [usbcore]
[<f992f758>] clear_port_feature+0x58/0x60 [usbcore]
[<f9930b37>] hub_port_reset+0xa7/0xc0 [usbcore]
[<f9930e1d>] hub_port_connect_change+0xfd/0x280 [usbcore]
[<f99312bb>] hub_events+0x31b/0x390 [usbcore]
[<f993135d>] hub_thread+0x2d/0xf0 [usbcore]
[<c0105f9e>] ret_from_fork+0x6/0x14
[<c0118ff0>] default_wake_function+0x0/0x20
[<f9931330>] hub_thread+0x0/0xf0 [usbcore]
[<c0104291>] kernel_thread_helper+0x5/0x14

Badness in set_phy_reg at drivers/ieee1394/ohci1394.c:267
Call Trace:
[<f9888230>] set_phy_reg+0x110/0x120 [ohci1394]
[<f9888e66>] ohci_devctl+0x76/0x5d0 [ohci1394]
[<c01112d4>] delay_tsc+0x14/0x20
[<f988af1f>] ohci_irq_handler+0x55f/0x800 [ohci1394]
[<c012403f>] do_timer+0xdf/0xf0
[<c01082ea>] handle_IRQ_event+0x3a/0x70
[<c01086b5>] do_IRQ+0xc5/0x1a0
=======================
[<c0106a34>] common_interrupt+0x18/0x20
[<f9888193>] set_phy_reg+0x73/0x120 [ohci1394]
[<f98a6d00>] delayed_reset_bus+0x0/0xd0 [ieee1394]
[<f9888e66>] ohci_devctl+0x76/0x5d0 [ohci1394]
[<f98af3b7>] csr1212_fill_cache+0x97/0x100 [ieee1394]
[<f98a6d00>] delayed_reset_bus+0x0/0xd0 [ieee1394]
[<f98a419c>] hpsb_reset_bus+0x3c/0x40 [ieee1394]
[<f98a6db4>] delayed_reset_bus+0xb4/0xd0 [ieee1394]
[<c0123e54>] run_timer_softirq+0xd4/0x1d0
[<c011fe3d>] __do_softirq+0x7d/0x80
[<c0108fd3>] do_softirq+0x43/0x60
=======================
[<c010873b>] do_IRQ+0x14b/0x1a0
[<c0106a34>] common_interrupt+0x18/0x20
[<c01235f9>] __mod_timer+0x119/0x1a0
[<f9933756>] usb_start_wait_urb+0x86/0xe0 [usbcore]
[<f993381b>] usb_internal_control_msg+0x6b/0x80 [usbcore]
[<f9933650>] timeout_kill+0x0/0x80 [usbcore]
[<f993381b>] usb_internal_control_msg+0x6b/0x80 [usbcore]
[<f99338c6>] usb_control_msg+0x96/0xb0 [usbcore]
[<f992f758>] clear_port_feature+0x58/0x60 [usbcore]
[<f9930b37>] hub_port_reset+0xa7/0xc0 [usbcore]
[<f9930e1d>] hub_port_connect_change+0xfd/0x280 [usbcore]
[<f99312bb>] hub_events+0x31b/0x390 [usbcore]
[<f993135d>] hub_thread+0x2d/0xf0 [usbcore]
[<c0105f9e>] ret_from_fork+0x6/0x14
[<c0118ff0>] default_wake_function+0x0/0x20
[<f9931330>] hub_thread+0x0/0xf0 [usbcore]
[<c0104291>] kernel_thread_helper+0x5/0x14

ohci1394: fw-host0: SelfID received outside of bus reset sequence
usb usb1: control timeout on ep0out
e1000: eth0 NIC Link is Up 100 Mbps Full Duplex
ieee1394: Host added: ID:BUS[0-00:1023] GUID[8a1cc7ffff0020ed]
ip1394: $Rev: 1198 $ Ben Collins <bcollins@debian.org>
ip1394: eth2: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)

More info available upon request.

Thanks,

Paul B.
[unhandled content-type:application/pgp-signature]
\
 
 \ /
  Last update: 2005-03-22 14:02    [W:0.030 / U:0.444 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site