lkml.org 
[lkml]   [2001]   [Oct]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [announce] [patch] limiting IRQ load, irq-rewrite-2.4.11-B5
Date
From
> I hear you, but I think isolation is important;
> If i am telneted (literal example here) onto that machine (note eth0 is
> not cardbus based) and cardbus is causing the loops then iam screwed.
> [The same applies to everything that shares interupts]

Worst case it sucks, but it isnt dead.

Once you disable the IRQ and kick over to polling the cardbus and the
ethernet both still get regular service. Ok so your pps rate and your
latency are unpleasant, but you are not dead.

For a shared IRQ we know we can safely switch to a 200Hz poll of shared
irq lines marked 'stuck'. The problem ones are non shared ISA devices going
mad - there you have to be careful not to fake more irqs than real ones
are delivered since some ISA device drivers "know" the IRQ is for them.

Even at 200Hz polling a typical cardbus card with say 32 ring buffer slots
can process 6000pps.

Alan
-
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at http://vger.kernel.org/majordomo-info.html
Please read the FAQ at http://www.tux.org/lkml/

\
 
 \ /
  Last update: 2005-03-22 13:04    [W:0.115 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site