lkml.org 
[lkml]   [2023]   [Mar]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] arm64: dts: amlogic: gxl: use gxl mdio multiplexer
Date
So the far, GXL SoCs were using the generic mmio register based mdio
multiplexer. This properly sets one of the glue register but the SoC
actually has 3 of those registers.

One of them sets the ID under which the internal phy will advertise
itself. If nothing sets this register before linux boots (like u-boot), the
internal phy path is broken.

To address this problem, a dedicated MDIO mux driver has been
introduced. Switch to this new driver.

Signed-off-by: Jerome Brunet <jbrunet@baylibre.com>
---
arch/arm64/boot/dts/amlogic/meson-gxl.dtsi | 25 +++++++++++-----------
1 file changed, 13 insertions(+), 12 deletions(-)

diff --git a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
index 6f3c2bc36919..17bcfa4702e1 100644
--- a/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
+++ b/arch/arm64/boot/dts/amlogic/meson-gxl.dtsi
@@ -773,16 +773,23 @@ mux {
};
};

- eth-phy-mux@55c {
- compatible = "mdio-mux-mmioreg", "mdio-mux";
+ eth_phy_mux: mdio@558 {
+ reg = <0x0 0x558 0x0 0xc>;
+ compatible = "amlogic,gxl-mdio-mux";
#address-cells = <1>;
#size-cells = <0>;
- reg = <0x0 0x55c 0x0 0x4>;
- mux-mask = <0xffffffff>;
+ clocks = <&clkc CLKID_FCLK_DIV4>;
+ clock-names = "ref";
mdio-parent-bus = <&mdio0>;

- internal_mdio: mdio@e40908ff {
- reg = <0xe40908ff>;
+ external_mdio: mdio@0 {
+ reg = <0x0>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ };
+
+ internal_mdio: mdio@1 {
+ reg = <0x1>;
#address-cells = <1>;
#size-cells = <0>;

@@ -793,12 +800,6 @@ internal_phy: ethernet-phy@8 {
max-speed = <100>;
};
};
-
- external_mdio: mdio@2009087f {
- reg = <0x2009087f>;
- #address-cells = <1>;
- #size-cells = <0>;
- };
};
};

--
2.39.2
\
 
 \ /
  Last update: 2023-03-27 00:45    [W:0.045 / U:0.208 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site