Messages in this thread Patch in this message | | | From | Krzysztof Kozlowski <> | Subject | [PATCH v2 1/2] nfc: mrvl: remove useless "continue" at end of loop | Date | Wed, 2 Jun 2021 13:20:10 +0200 |
| |
The "continue" statement at the end of a for loop does not have an effect. Entire loop contents can be slightly simplified to increase code readability. No functional change.
Suggested-by: Joe Perches <joe@perches.com> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@canonical.com>
---
Changes since v1: 1. Make it if-else-if as Joe suggested. --- drivers/nfc/nfcmrvl/usb.c | 8 ++------ 1 file changed, 2 insertions(+), 6 deletions(-)
diff --git a/drivers/nfc/nfcmrvl/usb.c b/drivers/nfc/nfcmrvl/usb.c index bcd563cb556c..6fec20abfd1e 100644 --- a/drivers/nfc/nfcmrvl/usb.c +++ b/drivers/nfc/nfcmrvl/usb.c @@ -319,13 +319,9 @@ static int nfcmrvl_probe(struct usb_interface *intf, if (!drv_data->bulk_tx_ep && usb_endpoint_is_bulk_out(ep_desc)) { drv_data->bulk_tx_ep = ep_desc; - continue; - } - - if (!drv_data->bulk_rx_ep && - usb_endpoint_is_bulk_in(ep_desc)) { + } else if (!drv_data->bulk_rx_ep && + usb_endpoint_is_bulk_in(ep_desc)) { drv_data->bulk_rx_ep = ep_desc; - continue; } } -- 2.27.0
| |