lkml.org 
[lkml]   [2018]   [Jun]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH] arm: dts: socfpga: denali needs nand_x_clk too
From
Date
Hi Masahiro,

On 06/26/2018 09:52 PM, Masahiro Yamada wrote:
> 2018-06-27 3:09 GMT+09:00 Miquel Raynal <miquel.raynal@bootlin.com>:
>> Hi Masahiro,
>>
>> On Tue, 26 Jun 2018 11:38:21 +0900, Masahiro Yamada
>> <yamada.masahiro@socionext.com> wrote:
>>
>>> 2018-06-25 23:55 GMT+09:00 Boris Brezillon <boris.brezillon@bootlin.com>:
>>>> On Mon, 25 Jun 2018 09:50:18 -0500
>>>> Dinh Nguyen <dinguyen@kernel.org> wrote:
>>>>
>>>>> On 06/22/2018 10:58 AM, Richard Weinberger wrote:
>>>>>> Masahiro,
>>>>>>
>>>>>> Am Freitag, 22. Juni 2018, 16:37:21 CEST schrieb Masahiro Yamada:
>>>>>>> Hi Richard,
>>>>>>>
>>>>>>>
>>>>>>> 2018-06-19 21:07 GMT+09:00 Richard Weinberger <richard@nod.at>:
>>>>>>>> The denali NAND flash controller needs at least two clocks to operate,
>>>>>>>> nand_clk and nand_x_clk.
>>>>>>>> Since 1bb88666775e ("mtd: nand: denali: handle timing parameters by
>>>>>>>> setup_data_interface()") nand_x_clk is used to derive timing settings.
>>>>>>>>
>>>>>>>> Signed-off-by: Richard Weinberger <richard@nod.at>
>>>>>>>> ---
>>>>>>>> Strictly speaking denali needs a ecc_clk too, but AFAIK such a clock
>>>>>>>> is not present on this SoC.
>>>>>>>> But my SoCFPGA knowledge is very limited.
>>>>>>>>
>>>>>>>> Thanks,
>>>>>>>> //richard
>>>>>>>> ---
>>>>>>>> arch/arm/boot/dts/socfpga.dtsi | 3 ++-
>>>>>>>> 1 file changed, 2 insertions(+), 1 deletion(-)
>>>>>>>>
>>>>>>>> diff --git a/arch/arm/boot/dts/socfpga.dtsi b/arch/arm/boot/dts/socfpga.dtsi
>>>>>>>> index 486d4e7433ed..562f7b375bbd 100644
>>>>>>>> --- a/arch/arm/boot/dts/socfpga.dtsi
>>>>>>>> +++ b/arch/arm/boot/dts/socfpga.dtsi
>>>>>>>> @@ -754,7 +754,8 @@
>>>>>>>> reg-names = "nand_data", "denali_reg";
>>>>>>>> interrupts = <0x0 0x90 0x4>;
>>>>>>>> dma-mask = <0xffffffff>;
>>>>>>>> - clocks = <&nand_clk>;
>>>>>>>> + clocks = <&nand_clk>, <&nand_x_clk>;
>>>>>>>> + clock-names = "nand", "nand_x";
>>>>>>>
>>>>>>>
>>>>>>> IMHO, this should be
>>>>>>>
>>>>>>> clocks = <&nand_clk>, <&nand_x_clk>, <&nand_x_clk>;
>>>>>>> clock-names = "nand", "nand_x", "ecc";
>>>>>
>>>>> No, it should be just the nand_x and ecc.
>>>>>
>>>>> There's already a patch to use the nand_x_clk and not the nand_clk.
>>>
>>>
>>> Different people try to fix the problem in different ways.
>>>
>>> I think it is due to miscommunication across sub-systems.
>>
>> Is the series named
>>
>> mtd: rawnand: denali: add new clocks and improve
>> setup_data_interface
>>
>> still valid?
>
> Yes.
> I believe V4 is valid.
>
>
> Information for Dinh Nguyen:
>
> http://patchwork.ozlabs.org/patch/933507/
> http://patchwork.ozlabs.org/patch/933487/
> http://patchwork.ozlabs.org/patch/933494/
> http://patchwork.ozlabs.org/patch/933506/
>
>
> If he is not convinced, I am open to discussion, though.

I wasn't aware of these patches. This patch is staged to go into
v4.17-rc3 through the arm-soc:

https://git.kernel.org/pub/scm/linux/kernel/git/arm/arm-soc.git/commit/arch/arm/boot/dts/socfpga.dtsi?h=fixes&id=4eda9b766b042ea38d84df91581b03f6145a2ab0

I think your patch will handle a case where only 1 clock is passed in,
so it should be okay right?

Dinh


\
 
 \ /
  Last update: 2018-06-27 16:56    [W:0.121 / U:0.024 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site