lkml.org 
[lkml]   [2017]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 13/14] qcom: mtd: nand: support for QPIC version 1.5.0
From
Date


On 06/29/2017 12:46 PM, Abhishek Sahu wrote:
> The current QCOM NAND driver only supports version 1.4.0
> QCOM QPIC NAND controller. This patch adds the support for
> version 1.5.0 which contains some of the registers at
> different offsets. The driver data contains the register offset
> field which is being initialized with its crossponding register

s/crossponding/corresponding

> offsets array. A new compatible string has been added for
> version 1.5.0 in BAM mode which uses version 1.5.0 register
> offsets.

Please split into 2 patches.

Thanks,
Archit

>
> Signed-off-by: Abhishek Sahu <absahu@codeaurora.org>
> ---
> .../devicetree/bindings/mtd/qcom_nandc.txt | 44 ++++++++++++++++++
> drivers/mtd/nand/qcom_nandc.c | 54 ++++++++++++++++++++--
> 2 files changed, 95 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
> index 87b9a56..11e2da2 100644
> --- a/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
> +++ b/Documentation/devicetree/bindings/mtd/qcom_nandc.txt
> @@ -4,6 +4,8 @@ Required properties:
> - compatible: must be one of the following:
> * "qcom,ebi2-nandc" - EBI2 NAND which uses ADM DMA like IPQ8064.
> * "qcom,qpic-nandc-v1.4.0" - QPIC NAND v1.4.0 which uses BAM DMA like IPQ4019.
> + * "qcom,qpic-nandc-v1.5.0" - QPIC NAND v1.5.0 which uses BAM DMA like IPQ8074.
> +
> - reg: MMIO address range
> - clocks: must contain core clock and always on clock
> - clock-names: must contain "core" for the core clock and "aon" for the
> @@ -130,3 +132,45 @@ nand@79b0000 {
> };
> };
> };
> +
> +nand@79b0000 {
> + compatible = "qcom,qpic-nandc-v1.5.0";
> + reg = <0x79B0000 0x1000>;
> +
> + clocks = <&gcc GCC_QPIC_CLK>,
> + <&gcc GCC_QPIC_AHB_CLK>;
> + clock-names = "core", "aon";
> +
> + dmas = <&qpicbam 0>,
> + <&qpicbam 1>,
> + <&qpicbam 2>;
> + dma-names = "tx", "rx", "cmd";
> +
> + #address-cells = <1>;
> + #size-cells = <0>;
> +
> + nandcs@0 {
> + compatible = "qcom,nandcs";
> + reg = <0>;
> +
> + nand-ecc-strength = <4>;
> + nand-ecc-step-size = <512>;
> + nand-bus-width = <8>;
> +
> + partitions {
> + compatible = "fixed-partitions";
> + #address-cells = <1>;
> + #size-cells = <1>;
> +
> + partition@0 {
> + label = "boot-nand";
> + reg = <0 0x58a0000>;
> + };
> +
> + partition@58a0000 {
> + label = "fs-nand";
> + reg = <0x58a0000 0x4000000>;
> + };
> + };
> + };
> +};
> diff --git a/drivers/mtd/nand/qcom_nandc.c b/drivers/mtd/nand/qcom_nandc.c
> index 24750e6..641e85d 100644
> --- a/drivers/mtd/nand/qcom_nandc.c
> +++ b/drivers/mtd/nand/qcom_nandc.c
> @@ -430,15 +430,18 @@ struct qcom_nand_host {
> * This data type corresponds to the nand driver data which will be used at
> * driver probe time
> * @ecc_modes - ecc mode for nand
> + * @regs_offsets - contains the register offsets array pointer.
> * @dma_bam_enabled - whether this driver is using bam
> */
> struct qcom_nand_driver_data {
> u32 ecc_modes;
> + const u32 *regs_offsets;
> bool dma_bam_enabled;
> };
>
> /* Mapping table which contains the actual register offsets */
> -static const u32 regs_offsets[] = {
> +/* NAND controller Version 1.4.0 mapping table */
> +static const u32 regs_offsets_v1_4_0[] = {
> [NAND_FLASH_CMD] = 0x00,
> [NAND_ADDR0] = 0x04,
> [NAND_ADDR1] = 0x08,
> @@ -471,6 +474,40 @@ struct qcom_nand_driver_data {
> [NAND_READ_LOCATION_3] = 0xf2c,
> };
>
> +/* NAND controller Version 1.5.0 mapping table */
> +static const u32 regs_offsets_v1_5_0[] = {
> + [NAND_FLASH_CMD] = 0x00,
> + [NAND_ADDR0] = 0x04,
> + [NAND_ADDR1] = 0x08,
> + [NAND_FLASH_CHIP_SELECT] = 0x0c,
> + [NAND_EXEC_CMD] = 0x10,
> + [NAND_FLASH_STATUS] = 0x14,
> + [NAND_BUFFER_STATUS] = 0x18,
> + [NAND_DEV0_CFG0] = 0x20,
> + [NAND_DEV0_CFG1] = 0x24,
> + [NAND_DEV0_ECC_CFG] = 0x28,
> + [NAND_DEV1_ECC_CFG] = 0x2c,
> + [NAND_DEV1_CFG0] = 0x30,
> + [NAND_DEV1_CFG1] = 0x34,
> + [NAND_READ_ID] = 0x40,
> + [NAND_READ_STATUS] = 0x44,
> + [NAND_DEV_CMD0] = 0x70a0,
> + [NAND_DEV_CMD1] = 0x70a4,
> + [NAND_DEV_CMD2] = 0x70a8,
> + [NAND_DEV_CMD_VLD] = 0x70ac,
> + [SFLASHC_BURST_CFG] = 0xe0,
> + [NAND_ERASED_CW_DETECT_CFG] = 0xe8,
> + [NAND_ERASED_CW_DETECT_STATUS] = 0xec,
> + [NAND_EBI2_ECC_BUF_CFG] = 0xf0,
> + [FLASH_BUF_ACC] = 0x100,
> + [NAND_CTRL] = 0xf00,
> + [NAND_VERSION] = 0x4f08,
> + [NAND_READ_LOCATION_0] = 0xf20,
> + [NAND_READ_LOCATION_1] = 0xf24,
> + [NAND_READ_LOCATION_2] = 0xf28,
> + [NAND_READ_LOCATION_3] = 0xf2c,
> +};
> +
> /* Frees the BAM transaction memory */
> static void free_bam_transaction(struct qcom_nand_controller *nandc)
> {
> @@ -2832,7 +2869,7 @@ static int qcom_nandc_probe(struct platform_device *pdev)
>
> nandc->ecc_modes = driver_data->ecc_modes;
> nandc->dma_bam_enabled = driver_data->dma_bam_enabled;
> - nandc->regs_offsets = regs_offsets;
> + nandc->regs_offsets = driver_data->regs_offsets;
>
> res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
> nandc->base = devm_ioremap_resource(dev, res);
> @@ -2902,16 +2939,24 @@ static int qcom_nandc_remove(struct platform_device *pdev)
> return 0;
> }
>
> -
> static const struct qcom_nand_driver_data ebi2_nandc_data = {
> .ecc_modes = (ECC_RS_4BIT | ECC_BCH_8BIT),
> .dma_bam_enabled = false,
> + .regs_offsets = regs_offsets_v1_4_0,
> };
>
> static const struct qcom_nand_driver_data qpic_nandc_v1_4_0_data = {
> .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
> .dma_bam_enabled = true,
> + .regs_offsets = regs_offsets_v1_4_0,
> +};
> +
> +static const struct qcom_nand_driver_data qpic_nandc_v1_5_0_data = {
> + .ecc_modes = (ECC_BCH_4BIT | ECC_BCH_8BIT),
> + .dma_bam_enabled = true,
> + .regs_offsets = regs_offsets_v1_5_0,
> };
> +
> /*
> * data will hold a struct pointer containing more differences once we support
> * more controller variants
> @@ -2923,6 +2968,9 @@ static int qcom_nandc_remove(struct platform_device *pdev)
> { .compatible = "qcom,qpic-nandc-v1.4.0",
> .data = (void *)&qpic_nandc_v1_4_0_data,
> },
> + { .compatible = "qcom,qpic-nandc-v1.5.0",
> + .data = (void *)&qpic_nandc_v1_5_0_data,
> + },
> {}
> };
> MODULE_DEVICE_TABLE(of, qcom_nandc_of_match);
>

--
Qualcomm Innovation Center, Inc. is a member of Code Aurora Forum,
a Linux Foundation Collaborative Project

\
 
 \ /
  Last update: 2017-07-04 11:58    [W:1.961 / U:0.924 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site