lkml.org 
[lkml]   [2017]   [May]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH] dt-bindings: power: New bindings for ltc3651-charger
On Fri, May 05, 2017 at 08:38:35AM +0200, Mike Looijmans wrote:
> This adds the devicetree bindings documentation for the LTC3651 battery charger.
>
> Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
> ---
> .../bindings/power/supply/ltc3651-charger.txt | 26 ++++++++++++++++++++++
> 1 file changed, 26 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
>
> diff --git a/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
> new file mode 100644
> index 0000000..a7dd80f
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt
> @@ -0,0 +1,26 @@
> +ltc3651-charger
> +
> +Required properties:
> + - compatible: "lltc,ltc3651-charger"
> + - acpr-gpios: Connect to ACPR output. See remark below.
> +
> +Optional properties:
> + - fault-gpios: Connect to FAULT output. See remark below.
> + - chrg-gpios: Connect to CHRG output. See remark below.

All the gpios need vendor prefix.

> +
> +The ltc3651 outputs are open-drain type and active low. The driver assumes the
> +GPIO reports "active" when the output is asserted, so if the pins have been
> +connected directly, the GPIO flags should be set to active low also.
> +
> +The driver will attempt to aquire interrupts for all GPIOs. If the system is
> +not capabale of providing that, the driver cannot report changes and userspace
> +will need to periodically read the sysfs attributes to detect changes.

If these are interrupts, then you should use the interrupt binding
instead (most GPIO controllers are also interrupt controllers).

> +
> +Example:
> +
> + charger: battery-charger {
> + compatible = "lltc,ltc3651-charger";
> + acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
> + fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
> + chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
> + };
> --
> 1.9.1
>

\
 
 \ /
  Last update: 2017-05-08 19:12    [W:0.433 / U:0.212 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site