lkml.org 
[lkml]   [2017]   [May]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] phy: ti-pipe3: Use TRM recommended settings for SATA DPLL
Date
The AM572x TRM [1], shows recommended settings for the
SATA DPLL in Table 26-8. DPLL CLKDCOLDO Recommended Settings.

Use those settings in the driver. The TRM does not show
a value for 20MHz SYS_CLK so we use something close to the
26MHz setting.

[1] - http://www.ti.com/lit/ug/spruhz6h/spruhz6h.pdf

Signed-off-by: Roger Quadros <rogerq@ti.com>
---
drivers/phy/phy-ti-pipe3.c | 10 +++++-----
1 file changed, 5 insertions(+), 5 deletions(-)

diff --git a/drivers/phy/phy-ti-pipe3.c b/drivers/phy/phy-ti-pipe3.c
index 9c84d32..0e564f3 100644
--- a/drivers/phy/phy-ti-pipe3.c
+++ b/drivers/phy/phy-ti-pipe3.c
@@ -118,12 +118,12 @@ static struct pipe3_dpll_map dpll_map_usb[] = {
};

static struct pipe3_dpll_map dpll_map_sata[] = {
- {12000000, {1000, 7, 4, 6, 0} }, /* 12 MHz */
- {16800000, {714, 7, 4, 6, 0} }, /* 16.8 MHz */
+ {12000000, {625, 4, 4, 6, 0} }, /* 12 MHz */
+ {16800000, {625, 6, 4, 7, 0} }, /* 16.8 MHz */
{19200000, {625, 7, 4, 6, 0} }, /* 19.2 MHz */
- {20000000, {600, 7, 4, 6, 0} }, /* 20 MHz */
- {26000000, {461, 7, 4, 6, 0} }, /* 26 MHz */
- {38400000, {312, 7, 4, 6, 0} }, /* 38.4 MHz */
+ {20000000, {750, 9, 4, 6, 0} }, /* 20 MHz */
+ {26000000, {750, 12, 4, 6, 0} }, /* 26 MHz */
+ {38400000, {625, 15, 4, 6, 0} }, /* 38.4 MHz */
{ }, /* Terminator */
};

--
2.7.4
\
 
 \ /
  Last update: 2017-05-22 10:10    [W:0.034 / U:1.160 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site