lkml.org 
[lkml]   [2016]   [May]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH 2/2] ARM: dts: igep0020: Add SD card write-protect pin.
Hi Enric!

On Fri, May 06, 2016 at 11:02:34PM +0200, Enric Balletbo i Serra wrote:
> A host device that supports write protection should refuse to write to
> an SD card that is designated read-only when write-protect is set. This
> is an optional feature of the SD specification.

Does it ever work on any IGEPv2? I have similar patch in my repo and there
is no difference when enabling write protection on SD card. Also schemantics
shows GPIO29 constantly pulled up with a resistor. Is there any board
revision with working WP? I'm just curious as patch is of course correct.

Best regards,
ladis

> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
> ---
> arch/arm/boot/dts/omap3-igep0020-common.dtsi | 11 +++++++++++
> 1 file changed, 11 insertions(+)
>
> diff --git a/arch/arm/boot/dts/omap3-igep0020-common.dtsi b/arch/arm/boot/dts/omap3-igep0020-common.dtsi
> index d6f839c..b697106 100644
> --- a/arch/arm/boot/dts/omap3-igep0020-common.dtsi
> +++ b/arch/arm/boot/dts/omap3-igep0020-common.dtsi
> @@ -194,6 +194,12 @@
> OMAP3630_CORE2_IOPAD(0x25f8, PIN_OUTPUT | MUX_MODE4) /* etk_d14.gpio_28 */
> >;
> };
> +
> + mmc1_wp_pins: pinmux_mmc1_cd_pins {
> + pinctrl-single,pins = <
> + OMAP3630_CORE2_IOPAD(0x25fa, PIN_INPUT | MUX_MODE4) /* etk_d15.gpio_29 */
> + >;
> + };
> };
>
> &i2c3 {
> @@ -250,3 +256,8 @@
> };
> };
> };
> +
> +&mmc1 {
> + pinctrl-0 = <&mmc1_pins &mmc1_wp_pins>;
> + wp-gpios = <&gpio1 29 GPIO_ACTIVE_LOW>; /* gpio_29 */
> +};

\
 
 \ /
  Last update: 2016-05-13 14:41    [W:0.092 / U:0.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site