lkml.org 
[lkml]   [2016]   [May]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
SubjectRe: [PATCH 2/2] ARM: dts: igep0020: Add SD card write-protect pin.
From
Hi Ladislav,

2016-05-13 14:37 GMT+02:00 Ladislav Michl <ladis@linux-mips.org>:
> Hi Enric!
>
> On Fri, May 06, 2016 at 11:02:34PM +0200, Enric Balletbo i Serra wrote:
>> A host device that supports write protection should refuse to write to
>> an SD card that is designated read-only when write-protect is set. This
>> is an optional feature of the SD specification.
>
> Does it ever work on any IGEPv2? I have similar patch in my repo and there
> is no difference when enabling write protection on SD card. Also schemantics
> shows GPIO29 constantly pulled up with a resistor. Is there any board
> revision with working WP? I'm just curious as patch is of course correct.
>

Note that the microSD formats do not support a write protection
switch, a host device that supports write protection should refuse to
write to an SD card that is designated read-only in this way, which is
an optional feature of the SD specification. As far as I know there is
only a use case for the IGEPv2, the TP close to the SD card can be
used as a write-protection switch, this is not an usual use case and
of course, this needs some wiring, but it's a feature used by someone.

> Best regards,
> ladis
>
>> Signed-off-by: Enric Balletbo i Serra <enric.balletbo@collabora.com>
>> ---
>> arch/arm/boot/dts/omap3-igep0020-common.dtsi | 11 +++++++++++
>> 1 file changed, 11 insertions(+)
>>
>> diff --git a/arch/arm/boot/dts/omap3-igep0020-common.dtsi b/arch/arm/boot/dts/omap3-igep0020-common.dtsi
>> index d6f839c..b697106 100644
>> --- a/arch/arm/boot/dts/omap3-igep0020-common.dtsi
>> +++ b/arch/arm/boot/dts/omap3-igep0020-common.dtsi
>> @@ -194,6 +194,12 @@
>> OMAP3630_CORE2_IOPAD(0x25f8, PIN_OUTPUT | MUX_MODE4) /* etk_d14.gpio_28 */
>> >;
>> };
>> +
>> + mmc1_wp_pins: pinmux_mmc1_cd_pins {
>> + pinctrl-single,pins = <
>> + OMAP3630_CORE2_IOPAD(0x25fa, PIN_INPUT | MUX_MODE4) /* etk_d15.gpio_29 */
>> + >;
>> + };
>> };
>>
>> &i2c3 {
>> @@ -250,3 +256,8 @@
>> };
>> };
>> };
>> +
>> +&mmc1 {
>> + pinctrl-0 = <&mmc1_pins &mmc1_wp_pins>;
>> + wp-gpios = <&gpio1 29 GPIO_ACTIVE_LOW>; /* gpio_29 */
>> +};

\
 
 \ /
  Last update: 2016-05-17 10:41    [W:0.169 / U:0.028 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site