Messages in this thread | | | From | Chen-Yu Tsai <> | Subject | [PATCH v10 0/2] mfd: axp20x: Add DT binding documentation | Date | Fri, 20 Feb 2015 19:19:26 +0800 |
| |
Hi everyone,
This is v10 of the axp20x series. v10 reverts back to the DT bindings from v8. This is the binding currently supported by the kernel drivers since 3.18. Mark Brown raised concern on the needless changes to active regulator bindings in v9.
Maxime, I dropped your Acked-by because of all the changes I've made. Please have a look again.
Mark (Brown), please take a look at the regulator bits in the second patch. If it looks good, could you give your Acked-by?
I hope we can get this series merged so we can move on to adding AXP221 support.
Regards, ChenYu
Changes since v9:
- Revert to bindings in v8 - Dropped new patches in v9 - x-powers,dcdc-workmode default changed to "current hardware setting", matching the regulator driver. - Reorganized regulator related properties into separate section. This should make it easier to read and also update for newer PMICs. - Regulator nodes should only be listed if they are to be managed by the OS.
Carlo Caione (2): mfd: AXP20x: Add bindings documentation dt-bindings: add vendor-prefix for X-Powers
Documentation/devicetree/bindings/mfd/axp20x.txt | 96 ++++++++++++++++++++++ .../devicetree/bindings/vendor-prefixes.txt | 1 + 2 files changed, 97 insertions(+) create mode 100644 Documentation/devicetree/bindings/mfd/axp20x.txt
-- 2.1.4
| |