lkml.org 
[lkml]   [2015]   [Dec]   [7]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] r8152: fix lockup when runtime PM is enabled
Date
When an interface is brought up which was previously suspended (via
runtime PM), it would hang. This happens because napi_disable is called
before napi_enable.

Solve this by avoiding napi_disable before the device is fully up.

While at it, remove WORK_ENABLE check from rtl8152_open (introduced with
the original change) because it cannot happen:

- After this patch, runtime resume will not set it during rtl8152_open.
- When link is up, rtl8152_open is not called.
- When link is down during system/auto suspend/resume, it is not set.

Fixes: 41cec84cf285 ("r8152: don't enable napi before rx ready")
Link: https://lkml.kernel.org/r/20151205105912.GA1766@al
Signed-off-by: Peter Wu <peter@lekensteyn.nl>
---
drivers/net/usb/r8152.c | 23 +++++++----------------
1 file changed, 7 insertions(+), 16 deletions(-)

diff --git a/drivers/net/usb/r8152.c b/drivers/net/usb/r8152.c
index d9427ca..b8b083e 100644
--- a/drivers/net/usb/r8152.c
+++ b/drivers/net/usb/r8152.c
@@ -3067,17 +3067,6 @@ static int rtl8152_open(struct net_device *netdev)

mutex_lock(&tp->control);

- /* The WORK_ENABLE may be set when autoresume occurs */
- if (test_bit(WORK_ENABLE, &tp->flags)) {
- clear_bit(WORK_ENABLE, &tp->flags);
- usb_kill_urb(tp->intr_urb);
- cancel_delayed_work_sync(&tp->schedule);
-
- /* disable the tx/rx, if the workqueue has enabled them. */
- if (netif_carrier_ok(netdev))
- tp->rtl_ops.disable(tp);
- }
-
tp->rtl_ops.up(tp);

rtl8152_set_speed(tp, AUTONEG_ENABLE,
@@ -3516,11 +3505,13 @@ static int rtl8152_resume(struct usb_interface *intf)
if (test_bit(SELECTIVE_SUSPEND, &tp->flags)) {
rtl_runtime_suspend_enable(tp, false);
clear_bit(SELECTIVE_SUSPEND, &tp->flags);
- napi_disable(&tp->napi);
- set_bit(WORK_ENABLE, &tp->flags);
- if (netif_carrier_ok(tp->netdev))
- rtl_start_rx(tp);
- napi_enable(&tp->napi);
+ if (tp->netdev->flags & IFF_UP) {
+ napi_disable(&tp->napi);
+ set_bit(WORK_ENABLE, &tp->flags);
+ if (netif_carrier_ok(tp->netdev))
+ rtl_start_rx(tp);
+ napi_enable(&tp->napi);
+ }
} else {
tp->rtl_ops.up(tp);
rtl8152_set_speed(tp, AUTONEG_ENABLE,
--
2.6.3


\
 
 \ /
  Last update: 2015-12-07 18:21    [W:0.031 / U:0.668 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site